Power Supply And Dynamic Focus Board Removal - Zenith ZCM-1490 Service Manual

Power Supply and
Dynamic Focus Board
Removal
The power supply and dynamic focus boards are at-
tached to the right metal side panel. To remove these
boards from the side panel:
1. Remove the power supply/dynamic focus board
assembly as described earlier.
2. Refer to Figure 3-12 and remove the appropriate
hex screws for either the power supply board or
the dynamic focus board. Lift the board away
from the panel and replace the screws.
00
DYNAMIC
FOCUS
BOARD
.
Figure 3-12. Power Supply and Dynamic Focus Board Removal
Disassembly Page 3-9