Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for AEG Powertools AEGLDM50
Summary of Contents for AEG Powertools AEGLDM50
-
Page 2: Table Of Contents
The reflective surface could reflect the beam back at the CONTENTS IMPORTANT SAFETY INSTRUCTIONS operator or other persons. Important safety instructions ...........1 Keep extremities in a safe distance from the moving parts. Laser Classification Specified Conditions of Use ...........2 Carry out periodic test measurements. Particularly before, during and after important measurements. -
Page 3: Specified Conditions Of Use
ERROR CODE TABLE TECHNICAL DATA Code Description Solution Dust and Water resistance IP54 Err01 Out of measuring range Measure in a proper range Receiving Lens 14 mm Focus 35 mm Err02 Reflect signal is too weak Choose a better surface Maximum Measuring Range 50 meters Err03... -
Page 4: Overview
OVERVIEW Single Pythagoras Area/ Volume Height difference Indirect Surface Measurement Measuring Reference Battery Status Memory Normal Measuring Mode Timer Continuous measure mode Minimum / Maximum for continuous Measure Among Values Addition / Subtraction Main Value ON / MEASURE SUBTRACT ► On ►... -
Page 5: Change Batteries
CHANGE BATTERIES CORNER PIN Change batteries when battery symbol is flashing. BELT CLIP 2x AAA click... -
Page 6: Function Switch, Pythagoras, Measuring Reference
FUNCTION SWITCH, PYTHAGORAS, MEASURING REFERENCE Area Volume Wall Distance Starting Point of Measure Pythagoras 1 90° Pythagoras 2 90° Pythagoras 3 90° Corner Pin Front Back (Standard automatical) -
Page 7: Single Distance Measuring
SINGLE DISTANCE MEASURING... -
Page 8: Permanent / Minimum-Maximum Measuring
PERMANENT / MINIMUM-MAXIMUM MEASURING Stop 2 sec 2 sec MIN / MAX °... -
Page 9: Add / Subtract Measuring
ADD / SUBTRACT MEASURING 1,000 m... -
Page 10: Area Measuring
AREA MEASURING... -
Page 11: Volume Measuring
VOLUME MEASURING... -
Page 12: Indirect Measuring (Pythagoras 1)
INDIRECT MEASURING (PYTHAGORAS 1) °... -
Page 13: Indirect Measuring (Pythagoras 2)
INDIRECT MEASURING (PYTHAGORAS 2) °... -
Page 14: Indirect Measuring (Pythagoras 3)
INDIRECT MEASURING (PYTHAGORAS 3) °... -
Page 15: Wall Area Measuring (Scenario 1)
WALL AREA MEASURING (SCENARIO 1) -
Page 16: Wall Area Measuring (Scenario 2)
WALL AREA MEASURING (SCENARIO 2) -
Page 17: Timer
TIMER MEMORY With the timer, the measurement The measured values are stored can be start delayed. For example continuously and automatically in to position a part in the measuring memory. beam. The stored values can be retrived by pushing the button Push button - Icon is displayed. -
Page 18: Basic Description On Example Of Area Measuring (1)
BASIC DESCRIPTION ON EXAMPLE OF AREA MEASURING (1) Turn On Choose Measuring Reference Choose Function Measure length Measure width Push Button Standard after turning on: Bottom After switching on the device is Level the device Level the device always on single distance and push and push Attention! Laser on! -
Page 19: Basic Description On Example Of Area Measuring (2)
BASIC DESCRIPTION ON EXAMPLE OF AREA MEASURING (2) View stored values Exit memory Switch off Push button 2 sec. Push button . Push button 2 sec (Memory must be exited before) Push + or push - - Stored values appears in the - Device switches off.
Need help?
Do you have a question about the AEGLDM50 and is the answer not in the manual?
Questions and answers