Name Of Each Part; Installation - IDTECK STAR PDL100 User Manual

STAR PDL100

4. Name of Each Part

5. Installation

1) Remove mechanical lockset previously installed.
2) Place an obstacle like a chair between door and doorframe to prevent the door close.
3) Install the STAR PDL100 LOCKSET to the door. Place the GUIDE BOLT upward.
4) Insert two GUIDE BAR into the GUIDE PIN holes of the LOCKSET.
5) Place the Installation Template through the GUIDE PIN at the indoor side and mark the hole
positions using center punch or pen, then place the Installation Template at the outdoor side
and mark the hole positions at the outdoor side.
6) Remove the STAR PDL100 LOCKSET again.
7) Drill the holes of φ16mm, φ32mm using hole cutter at the positions marked above paragraph
5).
8) Install the STAR PDL100 LOCKSET again and confirm that the GUIDE BOLT places
upward and the directions of LATCH BOLT and GUIDE BOLT are correct.
9) Put one rubber pad to the outdoor unit and insert the two connector cables through the upper
φ32mm hole then push the outdoor unit into the door.
10) Put one rubber pad to the indoor unit and put two connectors into the main PCB of indoor unit,
then position the two locking pins through the GUIDE PIN holes of LOCKSET then adjust
the position of indoor/outdoor units until the two units are correctly positioned and fix the two
units properly.
11) Fasten the indoor unit and outdoor unit then assemble the two units using 4 screws.
12) Confirm the direction of door handles and smooth operation of LOCKSET.
13) Do not close the door until you confirm the correct operation of the unit after you insert the
battery pack to the unit.
20020704
PROXIMITY DOOR LOCK
- 4 -
User's Manual