INTRODUCTION OLYMPUS Stylus Tough TG-5 Underwater Housing CWOM-TG5 and WHOM-TG5 ※ Thank you for purchasing the RECSEA CWOM-TG5 or WHOM-TG5 Underwater Housing. ※ To ensure proper and safe use, please thoroughly read this manual. ※ Improper use may cause leakage causing irreparable damage to your digital camera.
※ RECSEA original Secure-Latch locking system for easy opening and closing. ※ Quality silicone O-ring. ※ Complete camera function control. ※ Variety of supported RECSEA original options. PACKAGE CONTENTS Be sure all items listed here are included: ・Housing ・Wrist Strap ・Strobe Mask-External Strobe Connection ・Reserve O-ring ・O-ring Grease w/O-ring Removal Pick...
Serial Number ※ Dealer: Stamp your company name and contact information, purchase date, model and serial number. Recsea/Seatool Manufacturing & Sales NTF CORPORATION UH Division 390-1 Mii, Midori-Ku, Sagamihara-Shi Kanagawa 252-0151, Japan T: +81 (0)50-7541-0294 F: +81 (0)42-780-5720 http://www.seatool.net E-mail: info@seatool.net...
※ Please refer to camera manual for explanation of camera controls. OPENING AND CLOSING THE BACK COVER ※ Please do the following operations in a clean area with low humidity and dust. To OPEN, press Lock Lever while pulling Secure-Latch away from housing main body. To CLOSE, press Secure-Latch into place making sure the latch on the underside is properly placed in the Secure-Latch groove attached to the main housing body.
REMOVING CAMERA CAUTION! After use in water, water will remain in gaps between housing, back cover and Secure-Latch. Wipe any water off housing with a soft dry towel to prevent water from falling on camera. 1. Pull Control Dial outward away from housing. 2.
CAUTION! Seatool/Recsea STRONGLY recommends the use of Seatool/Recsea genuine tray and grip assemblies listed below under OPTIONS. Leakage or damages due to the use of non-genuine options are NOT covered under warranty. ※The Accessory Shoe can be used for installation of a target light. Please be mindful of the weight of the light intended for use.
※ Thoroughly clean O-ring groove. Be sure to also apply a thin layer of grease to O-ring Contact Surfaces. ※ This housing uses one (1) O-ring. Please be sure to install O-ring as shown. Failure to do so will result in water leakage. 1.
・AD-M52-TG3 Quick M52 Mount Adapter (Bayonet Type) ・AD-M67-TG3 Quick M67 Mount Adapter (Bayonet Type) ・AD-28AD-TG3 Quick INON 28AD Mount Adapter (Bayonet Type) ・AD-LD-TG3 Quick INON 28LD Mount Adapter (Bayonet Type) ・AD-M67D-TG5AL Aluminum M67 Port Ring ・SAL-02-TG3 Bayonet Flip Close-Up Lens 50mm x2 ・SAL-03-TG3 Bayonet Flip Close-Up Lens 20mm x3 ・WH-CWOM-TG5 O-ring ・Seatool-OG3ml O-ring Grease 3ml Tube w/O-ring Pick...
Page 10
Seatool/Recsea will repair manufacturing defects free of charge during the warranty period when product is used in accordance with this manual. This warranty is only valid for housings purchased from authorized Seatool/Recsea international dealers. Damage due to customer use, and for any consumable parts, the repairs will be charged at normal rates. Shipping costs to and from dealer, or Japan if necessary, shall be born by the customer for warranty and all other cases.
Need help?
Do you have a question about the Recsea CWOM-TG5 and is the answer not in the manual?
Questions and answers