Backyard X-Scapes Bamboo Installation

Backyard X-Scapes Bamboo Installation

Advertisement

"Helping Create a New Paradise Everyday"

Installation on Existing Chain Link Fence

Required tools/materials:
• Pliers, Diagonal Cutter
• Tie Wire (14-16 gauges galvanized)
1) Have helper straighten out the bamboo roll to eliminate any kinks.
2) Have helper hold bamboo roll against chain link fence to ensure that bamboo roll is level and one inch
above the ground. (helpful hint- set bamboo on top of one inch thick scrap piece of lumber)
3) Attach bamboo roll to chain link fence with galvanized steel tie wire every twelve inches altering top
to bottom. Make sure that the fence is straight and level. Trim excess wire
4) Enjoy your beautiful, tropical, eco-friendly bamboo fence!

Installation on Block/Brick Wall

Required tools/materials:
• Cordless drill
• 2x4 treated lumber for horizontal rails
Powder actuated tool with proper load and nail or Topcon system (to attach rails)
• Desk screws
• Tapered drill bit with countersink attachment
1) Attach 2x4 near top and bottom of wall utilizing either your PAT, or Topcon system. Make sure the
horizontal rail is level and flush with the wall (remove excess mortar prior to installation
2) Have helper hold flattened bamboo roll against horizontal rails. Pre-drill the bamboo poles with a drill
bit slightly smaller than the diameter of the deck screw (this protects the bamboo from cracking or
splitting). Fasten bamboo roll onto horizontal tails at 12'' increments. Alternate top to keep fence
straight and level.
3) Enjoy your beautiful, tropical, eco-friendly bamboo fence!
Bamboo Fencing Installation
www.BackyardXScapes.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Bamboo and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Backyard X-Scapes Bamboo

  • Page 1 1) Have helper straighten out the bamboo roll to eliminate any kinks. 2) Have helper hold bamboo roll against chain link fence to ensure that bamboo roll is level and one inch above the ground. (helpful hint- set bamboo on top of one inch thick scrap piece of lumber) 3) Attach bamboo roll to chain link fence with galvanized steel tie wire every twelve inches altering top to bottom.
  • Page 2 • Tapered drill bit with countersink attachment 1) Check that existing wood posts are secure and free of rot 2) Have helper hold flattened bamboo roll against either side of the existing fence. Raise bamboo roll 1'' above ground level if necessary (alleviates soaking up moisture)

Table of Contents