Resetting The Control To Factory Settings - Nordmann AT4 D Service Manual

2.10

Resetting the control to factory settings

Caution! When resetting the control to factory settings, any modified settings in the user level are lost.
Select "FactoryReset" in the engineering menu, then press the <Set> key.
Engineering
Min.Request :20/25%
Stop Mode :Switch
Instab.Temp.:Set
FactoryReset:Set
Count Down :Set
Esc
The reset dialogue shows up in the display. Press the <Yes> key to reset the control to factory set-
tings. The control is reset to factory settings and restarted.
Note: By pressing the <No> key the reset procedure can be aborted. The control returns to the engi-
neering menu.
FactoryReset
Are you sure?
No Yes
Set
AT4D
STARTUP:
INIT MODULE
AT4D 65kg/h 400V3
Steam Bath :Standby
Temperature :34°C
Setpoint :48°C
2011-08-31 12:00:00
Menu Light Start
11