Hyundai HY2175 User Manual page 15

TORQUE ADJUSTMENT
NOTE
The torque control knob should only be operated when the drill is not in use.
Adjusting the torque setting whilst the drill is running, may cause irreversible damage to
the drill that will not be covered by the warranty.
3.21 To adjust the torque setting, allow the drill to come to a complete stop.
3.22 Turn the torque control to one of the 20+1 different torque settings depending on the
type of job you are doing.
3.23 The lower the number the less amount of torque will be applied.
3.24 If you exceed the torque for the selected torque setting, the drill clutch will slip to
prevent damage to the drill.
3.25 Turning the torque control to the image of a drill bit applies maximum torque with no
clutch slip.
GEAR SWITCH
NOTE
The gear switch should only be operated when the drill is not in use.
Adjusting the torque setting whilst the drill is running, may cause irreversible damage to
the drill that will not be covered by the warranty.
3.26 The drill has a 2 speed gear selection switch.
3.27 Selecting gear speed 1 is for controlled screw driving and low speed work.
3.28 Selecting gear speed 2 is for drilling into masonry, wood and steel.
DRILLING
3.29 Check the drill bit is correctly inserted and fastened tightly before starting the drill.
3.30 Use properly sharpened drill bits designed for use with the drill.
3.31 At the start of each drilling, select a lower speed.
3.32 For large holes, drill a smaller pilot hole first and then enlarge the hole using a larger
drill bit.
DRILLING WOOD
3.33 For drilling wood, use a drill bit designed for wood.
3.34 Protect or fasten the work piece in a suitable vice or holder.
3.35 Mark the position of the hole to be drilled with a sharp tool.
3.36 Do not apply excessive pressure against the work piece with the drill.
15