Table of Contents
Advertisement
TRE/TR/TRH-G2/TRH-G2P
Evaluation Кit
Application Notes
Version 1.3
Last Revised January 16, 2019
All contents in this manual are copyrighted by JAVAD GNSS.
All rights reserved. The information contained herein may not be used, accessed, copied,
stored, displayed, sold, modified, published, or distributed, or otherwise reproduced without express
written consent from JAVAD GNSS.
Advertisement
Table of Contents
Summary of Contents for Javad TRE-G2 Series
- Page 1 Version 1.3 Last Revised January 16, 2019 All contents in this manual are copyrighted by JAVAD GNSS. All rights reserved. The information contained herein may not be used, accessed, copied, stored, displayed, sold, modified, published, or distributed, or otherwise reproduced without express...
-
Page 3: Terms And Conditions
Terms and Conditions IN CONNECTION WITH OBTAINING SUBSTITUTE PRODUCTS OR USE – JAVAD GNSS receivers are designed to be used by a professional. SOFTWARE, CLAIMS BY OTHERS, INCONVENIENCE, OR ANY OTHER The user is expected to have a good knowledge and understanding of COSTS. -
Page 4: Weee Directive
Confidential Information, you about the take-back and recycling of this product, please contact your shall give JAVAD GNSS immediate notice so that it may seek a protec- supplier where you purchased the product or consult. - Page 5 - TRH-G2P Interface Cross Adapter p/n 05-670071-01 Board Connector The TRE/TR/TRH-G2/TRH-G2P Evaluation Kit provides an easy connec- tion to any of JAVAD GNSS OEM receiver boards. It is designed for use in laboratories and allows: • JAVAD GNSS OEM boards testing;...
-
Page 6: Power Connection
OEM board power specifications. See particular OEM board specifications on www.javad.com. Note: CAUTION: Evaluation Kit does not provide any over-voltage protection. Connecting Evaluation Kit to voltage exceeding particular OEM board power voltage range may cause damage of OEM board and Evaluation Kit board. - Page 7 Wire 2 In some cases, to connect other external devices with Evaluation Kit RS-422 port, not Null-modem, but Straight Through RS-422 cable may Wire 3 be used. Wire 4 Wire 5 Shield shell Shield + Drain Wire shell Shield www.javad.com...
-
Page 8: Ethernet Connection
Warning: Because both J116 USB type B and J115 USB type Mini-AB Female connec- one of them should be configured as Base (Server), while another re- tors are physically connected to one and the same USB port, only one USB cable at a www.javad.com... -
Page 9: Can Connection
For OEM receiver Ethernet port connection with LAN, the Straight Through (Patch Cord) cable usually used. Straight Through cable CAN_L Pair 1: Wire 1 CAN_L should be wired according to the wiring table below. CAN_GND Pair 2: Wire 1 CAN_GND TXD+ TXD- CAN_H Pair 1: Wire 2 CAN_H www.javad.com... -
Page 10: Safety Warnings
• Without the user thoroughly understanding operator’s manual. • After disabling safety systems or altering the product. • With unauthorized accessories. • Contrary to applicable laws, rules, and regulations. Warning: THE EVALUATOION KIT SHOULD NEVER BE USED IN DANGEROUS ENVIRON- MENTS. www.javad.com... -
Page 11: Power Supply
If this product has been dropped, altered, transported or shipped without proper packaging, or otherwise treated without care, erro- neous measurements may occur. Inform JAVAD GNSS immediately if this product does not function properly. Only allow authorized JAVAD GNSS warranty service centers to service or repair this product. www.javad.com... - Page 12 900 Rock Avenue, San Jose, CA 95131, USA Phone: +1(408)770-1770 Fax : +1(408)770-1799 www.javad.com All rights reserved © JAVAD GNSS, Inc., 2019...