Optikinetics OPTI GoboPro+ LED Instructions

GoboPro+ LED
Instructions

Important Safety Instructions

When using your projection equipment basic safety precautions
should be followed:
1. Read and understand all instructions before using the equipment.
2. Close supervision is necessary when any appliance is used by, or near, children.
3. Care must be taken, as burns can occur from touching hot parts.
4. Do not operate appliance with a damaged cord, or if the appliance has been
dropped, or damaged, until it has been examined by a qualified engineer.
5. Position the cord so that it will not be tripped over, pulled, or come into contact with
hot surfaces.
6. If an extension cord is necessary, a cord with a current rating at least equal to that of
the appliance should be used. Cords rated for less amperage than the appliance may
overheat.
7. Always unplug appliance from electrical outlet before cleaning and servicing and
when not in use. Never yank cord to pull plug from outlet. Grasp plug and pull to
disconnect.
8. Let appliance cool completely before packing. Loop cord loosely around appliance
when storing.
9. To reduce risk of electric shock, do not immerse product in water or other liquids.
10. To reduce the risk of electric shock, do not dismantle this appliance.
11. Do not attempt to service the projector unless you are qualified and working under
the direction of the manufacturer
12. The use of an accessory attachment not recommended by the manufacturer may
cause a risk of fire, electric shock, or personal injury.
13. A safety chain or cable must be fitted to the projector and secured to an immovable
object where applicable. The securing point must be able to withstand the shock weight
of the projector should it fall.
14. After any maintenance or cleaning all parts must be absolutely dry before refitting to
the projector.
15. During focussing of the projected image beware of moving the projection lens too
far, as this may cause the lens to become separated from the projector, and perhaps to
dropped and broken which may cause injury.
16. Flammable surfaces should be 0.5m away from the front of the projector
Designed and Manufactured in the UK by [OPTI] Kinetics
1