Summary of Contents for Almeco JetBlack
- Page 1 DRYING & BLOW-OFF SOLUTIONS www.almeco.eu L ACK - BLOW-OFF CLEANING STATIONS JetBlack Blower-Powered Personnel Cleaning Stations Installation, Operation and Maintenance instructions For Wall-Mounted & Portable versions...
-
Page 2: Table Of Contents
Maintenance & service 10. Spares list 11. Trouble shooting 12. Rain cover installation (wall mounted only) 13. Motor brush replacement 14. Warranty information 15. WEEE recycling & materials disposal ALMECO nv Air and water technologies Royennestraat 51, B-7700 Moeskroen info@axongroup.com - www.almeco.eu... -
Page 3: Important Information
Always ensure that the power is isolated before commencing any maintenance on this product. 2. EQUIPMENT ARRIVAL / INSPECTION If there are any shortages, discrepancies or damage to your product upon delivery of your JetBlack unit, please immediately contact Almeco. -
Page 4: Installation Safety Information & Wiring Diagram
Please refer to the JetBlack rating plate for the full details – these are located on the side of the JetBlack Touch Switch Box. • It is recommended that the JetBlack is connected to an electrical supply that is surge protected and in compliance with local codes. - Page 5 • The On/Off switch is located behind the carrying handle on the main body. Press ‘I’ to turn the unit On, and ‘O’ to turn off. • If an anti-static unit has been fitted, a second switch is located on the front of the JetBlack – the switch must be on ‘I’ for the anti-static pack to work correctly.
-
Page 6: Rating
• The power supply must be disconnected and secured against restoration. • Observe personal safety regulations. • Filters – Almeco recommends that the filter is inspected at least once a month, and replaced after a maximum of 3 months. Almeco’s internal part number for this filter is B3.003.054. -
Page 7: Spares List
B3.003.054 Filter Guard, secured with M5 screw 10. SPARES LIST If you require any spare parts for your JetBlack unit, either Wall Mounted or Portable versions, please refer to the following Almeco part numbers: Almeco Part Number Part Description Moulded JetBlack with full OSHA nozzle assembly (includes dip- B3.003.049... -
Page 8: Trouble Shooting
12. RAIN COVER INSTALLATION GUIDE (WALL MOUNTED ONLY) • Find suitable location for JetBlack unit, ensuring that the surface can support the total weight of the JetBlack and cover. • Locate fixings suitable for the substrate you are mounting to and secure JetBlack using the four holes in the baseplate. -
Page 9: Motor Brush Replacement
L ACK - BLOW-OFF CLEANING STATIONS 13. MOTOR BRUSH REPLACEMENT • Ensure that the supply power is turned off, and that the JetBlack is electrically isolated and locked off. • Remove all screws retaining the main JetBlack outer cover, and lift cover off (see below). -
Page 10: Warranty Information
Almeco, and alterations not performed by Almeco. The Almeco warranty is limited to the repair or replacement of items shipped by Almeco. At no time will Almeco be liable for any of the costs to the buyer for labour, transportation or down-time resulting from defective equipment furnished by Almeco, or our suppliers.
Need help?
Do you have a question about the JetBlack and is the answer not in the manual?
Questions and answers