Recording To Mds; Recording To An Md - Sony NET MD MDS-JB980 Operating Instructions Manual

Recording to MDs

Recording to an MD

If the MD has been partially recorded,
recording starts after the recorded tracks.
1
Turn on the amplifier and programme
source, and select the source on the
amplifier.
2
Press ?/1 to turn on the deck.
The STANDBY indicator turns off.
3
Load a recordable MD into the slot
(page 19).
4
Press INPUT repeatedly to select the
input jacks (connector) connected to
the programme source.
When the source is
connected to the
DIGITAL OPTICAL IN
connector
DIGITAL COAXIAL IN jack
ANALOG IN jacks
5
Press REC z.
The deck changes to recording pause.
6
If necessary, adjust the recording level.
For details, see "Adjusting the recording
level" on page 15.
7
Press H or X , then start playing the
desired source to record.
Operations you may want to do
during recording
To
Stop recording
Pause recording
Resume recording after
pausing
Eject the MD
1)
To change the display while
recording
Press DISPLAY/CHAR (or DISPLAY)
repeatedly to change the display.
Each press of the button changes the display
cyclically as follows:
Note
Set INPUT to
Note that, depending on the status of the deck, the
display may not conform with the cycle shown below.
OPT
Track number and recorded time of the current
track t Track number and remaining
COAX
recordable time
ANALOG
input signal (setting value of the recording
level) t Sampling frequency indication
2)
3)
Press
x
X
H or X
1)
EJECT A after stopping
recording
The track number increases by one.
2) on the MD t Level of the
Time shown in the display differs depending on
the setting of REC MODE.
"FS -- kHz" appears while the analogue signal is
input.
3)
9
GB