Advertisement

Quick Links

WCC31 USER MANUAL
Ver.01/2018
Copyright ©2005-2018 ISPRING WATER SYSTEMS, LLC. All rights reserved.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WCC31 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Ispring WCC31

  • Page 1 WCC31 USER MANUAL Ver.01/2018 Copyright ©2005-2018 ISPRING WATER SYSTEMS, LLC. All rights reserved.
  • Page 2 Open the box and remove all of the components. Inspect them to ensure nothing was damaged during shipping. If any part is cracked or broken, please immediately contact iSpring Customer Support for a replacement. Recommended tools list ● Variable speed drill with two bits: ¼” (for drilling a hole on PVC drain pipe), ½”...
  • Page 3 Step 1 – Faucet Install (Standard Non-Air-Gap Faucet) Be sure to turn off the cold water line before you start. 1. Most sinks have an extra hole for the mounting of additional faucets, sprayers or soap dispensers. If your sink does not already have an additional hole, you will want to drill a ½”...
  • Page 4 2. Disconnect the water supply line from the cold water connection underneath the sink. Wrap the male end of the water supply connector with 3-4 wraps of Teflon tape to ensure a proper seal. Screw the female side of the feed water adapter onto the cold water line first, and then screw on the cold water line to the male end of the feed...
  • Page 5 Step 4 – Fitting and Tube Connections Fittings: Wrap the male end of the fittings with 4-5 wraps of Teflon tape to ensure a proper seal, and then screw them into each side of the system. Do not over-tighten. Insert the tube into the fitting until you reach the ⅝” mark on the Supply Tube: tube.
  • Page 6 To disconnect: 1. Remove the blue lock clip from the fitting. 2. With the blue lock clip removed, use your thumb and index finger to hold down the lock sleeve. This will release the metal teeth holding the tube in place. While holding the lock sleeve down with that hand, use your other hand to remove the tube from the fitting.
  • Page 7 Step 6 – How to Change Filters 1. Shut off the cold water supply valve. Place a bucket or towel under the system to catch any water spills. 2. If there is enough room under the sink and the filter system is hung on the wall, you can twist the filter housing off without removing the system from the wall.
  • Page 8 Warranty Registration To register your product for the warranty, please visit our website at 123filter.com and go to the “Warranty Registration” tab. We provide a 30-day money back guarantee, a 1-year manufacturer warranty, and lifetime tech support for all of our products. However, we do not have the order information from websites other than 123Filter.com (Amazon, Home Depot, etc.), so please be sure to fill in that information upon registration of your system.

Table of Contents