ScreenBeam USB Transmitter 2 Installation Manual

installationguide
ScreenBeam
USB Transmitter 2
Catalog# SBWD200TX02
This installation guide provides instructions on how to
set up and pair your ScreenBeam USB Transmitter 2 to
a ScreenBeam wireless display receiver. This will enable
users to wirelessly display content from a PC or laptop to
a monitor or projector.
Note: ScreenBeam wireless display receiver is not
included. Visit www.screenbeam.com
A. Install the Application Software
Download ScreenBeam wireless display software to
1.
your PC or laptop from
www.actiontec.com/products/sbupdate.php.
Click ScreenBeam_Setup.exe and follow the
2.
onscreen instructions.
Note: The software supports silent install/uninstall
mode to run the setup.exe from the command line.
Install command line:
ScreenBeam_Setup.exe -sp"-s"
Uninstall command line:
ScreenBeam_Setup.exe -sp"-s -x -v"/qn""
B. Set up the ScreenBeam Receiver
Place the receiver next to the monitor or projector.
1.
Using an HDMI cable, connect one end to the
2.
receiver's HDMI port and the other end to the HDMI
port on the monitor or projector.
screenbeam.com
™
for more information.
CONTINUED