Lamona TAP6000 Quick Start Manual

TAP6000 – 3 in 1 Hot Tap
Guarantee (UK only):
Your tap has the benefit of a comprehensive manufacturer's guarantee, details of which are shown on your
Proof of Purchase Document. Any claim during the period of the guarantee must be accompanied by the Proof
of Purchase. The product must be correctly installed and operated in accordance with the manufacturer's
instructions and used for normal domestic purposes. This guarantee does not cover accidental damage,
misuse or alterations which are likely to affect the product. The guarantee is invalid if the product is tampered
with, or repaired by any unauthorized person. The guarantee in no way affects your statutory or legal rights.
Care Instructions for your Kitchen Sink Mixer:
To maintain the appearance of this tap, ensure that it is regularly cleaned only using a clean, soft damp cloth.
A solution of warm water and a mild liquid detergent may be used where necessary, and then the fitting rinsed
thoroughly and wiped dry. Any other cleaning action will invalidate your warranty.
Abrasive cleaners, scouring cleaners and acidic cleaners must not be used under any circumstances. Avoid
contact with all solvents (including chlorinated solvents, ketones or acetones as these may result in surface
deterioration or etching). Also avoid contact with any harsh household chemicals such as oven cleaners, drain
cleaners, rust removers, paint strippers and toilet bowl cleaners, bar keepers friend or Brasso.
Where the tap has a removable aerator on the spout exit it can be removed and cleaned periodically to
maintain optimum flow performance.
Important Technical Data:
Minimum operating pressure (hot): 0.75 bar
Maximum operating pressure: 5.5 bar*
Flow characteristics: Domestic Hot & Cold
share outer single flow spout.
Boiled water: Through centre spout channel.
*If these temperatures or pressures are exceeded, even for short periods, damage can result. In these
instances a thermostatic mixing or pressure reducing valve should be installed.
This product is manufactured in accordance with recognised European standards. Please ensure that your
kitchen mixer is fitted in accordance with Local Water Byelaws. Where hot and cold water mix within the
tap, then suitable non return (check) valves should be installed to both the hot and cold supplies to
prevent backflow, a preinstalled non return valve on the cold supply flexi hose (B1) is already supplied (see
instructions key).
Hot and cold supply pressures should be as closely balanced as possible for best results. Supply pipes should
maintain the maximum diameter until immediately before the fitting. The differential between the hot and cold
water supply temperatures should be sufficient to allow correct mixing function.
These installation guidelines have been prepared for your direction and you must exercise due care at all
times. We do not accept responsibility for problems that may occur through improper installation. Whilst
assembling the tap take care not to accidentally loosen any factory fixed assemblies.
This tap has been 100% assembly tested; therefore you may expect a small residual amount of water to
remain in the tap when delivered. Any water marks can be removed using the above care advice.
Minimum operating pressure (cold): 2.5 bar (with filter) /
1.0 bar (without filter)
Maximum domestic hot water temperature: 70°C*
Recommended domestic hot water temperature: 46°C
04-17