Screen Menu - Sony Esprit TAV-L1 Operating Instructions Manual

Reset
Resets the [Treble], [Bass] and [Balance] settings to
the factory settings.
1
Press (OK) to select [Reset].
2
Press M/m to select [OK], then press
(OK).
Dual Sound
Selects the sound from the speaker for a stereo or
bilingual broadcast.
1
Press (OK) to select [Dual Sound].
2
Press M/m to select one of the following,
then press (OK).
• [Stereo]/[Mono]: For a stereo broadcast.
• [A]/[B]/[Mono]: For a bilingual broadcast,
select [A] for sound channel 1, [B] for sound
channel 2, or [Mono] for a mono channel, if
available.
Tip
If you select other equipment connected to the system,
set [Dual Sound] to [Stereo], [A] or [B].
Note
When DVD is selected, the [Dual Sound] menu does not
appear.

Screen menu

Screen
Auto Format
Screen Format
RGB Center
Select: Set:
You can select the options listed below on the Screen
menu. To select options, see "Navigating through
menus" (page 38).
Auto Format
Automatically changes the screen format according to
the broadcast signal.
1
Press (OK) to select [Auto Format].
2
Press M/m to select [On], then press
(OK).
To keep your setting, select [Off].
Tips
• Even if you have selected [On] or [Off] in [Auto
Format], you can always modify the format of the
screen by pressing
• [Auto Format] is available for PAL and SECAM
signals only.
Screen Format
For details about the screen mode, see page 22.
1
Press (OK) to select [Screen Format].
2
Press M/m to select [Wide], [Smart],
[4:3], [14:9] or [Zoom] (see page 22 for
details), then press
RGB Center
Adjusts the horizontal picture position so that the
picture is in the middle of the screen.
1
Press (OK) to select [RGB Center].
2
Press </, to adjust the centre of the
picture between -5 and +5, then press
(OK).
Tip
This option is only available if an RGB source has been
connected to the Scarts connectors
2/ 2 on the rear of the system.
On
Smart
0
Back: End:
OK MENU
repeatedly.
(OK).
1/ 1 or
41
GB