TEFAL Effectis Easy Manual page 6

• Your steam generator is fitted with an iron
• Place the iron's temperature control dial according to
SETTING THE TEMPERATURE AND STEAM OUTPUT ACCORDING
Synthetics, Silk
acetate, acrylic, polyamide)
Wool**, Viscose
Linen, Cotton
OK
EFFECTIS Iron temperature setting:
- Start with the fabrics to be ironed at a low temperature
- Mixed fibre fabric: set the ironing temperature to the
• If you put the temperature control dial in the "min"
**If you are ironing woolen garments, press repeatedly on the steam shot button
11
Regulation
EFFECTIS
(depending on model)
temperature control dial.
the type of fabric to be ironed (see table below).
TO TYPE OF FABRIC TO BE IRONED
TYPE OF FABRICS SETTING TEMPERATURE CONTROL
•
( polyester,
••
•••
Warning, fabrics with the symbol
suitable for ironing.
(•) and finish with those which need higher
temperatures (••• or Max).
setting for the most delicate fabric.
position, the iron does not become hot.
without placing the iron on the garment. This will avoid it becoming shiny.
are not
Important: whenever you start using your iron and
whenever you reduce the temperature during use,
the iron is fully ready for use when its iron light goes
out. During use, when you increase the temperature
of the iron, you can start ironing immediately.
• While ironing, the iron light turn on and off, as the
temperature adjusts without interrupting ironing.
• If you are in doubt about the type of fabric an item of
clothing is made from, check the label.
**If you are ironing woolen garments, press repeatedly
on the steam shot button without placing the iron on
the garment. This will avoid it becoming shiny.
ECO MODE: Your steam generator iron has an ECO
mode function which uses less power whilst still
guaranteeing a sufficient steam flow for you to iron
your garments properly. In order to use this
function, once the Temperature control dial has
been correctly set (see table above), press on the
ECO mode button located on the control panel. The
ECO mode can be used on all types of fabrics,
nevertheless for very thick or very creased fabrics,
we recommend that you use the normal steam
flow for best results.
12