Advertisement
Owner's Manual & Safety Instructions
Save This Manual
operating, inspection, maintenance and cleaning procedures. Write the product's serial number in the
back of the manual near the assembly diagram (or month and year of purchase if product has no number).
Keep this manual and the receipt in a safe and dry place for future reference.
When unpacking, make sure that the product is intact
and undamaged. If any parts are missing or broken,
please call 1-888-866-5797 as soon as possible.
©
Copyright
2017 by Harbor Freight Tools
No portion of this manual or any artwork contained herein may be reproduced in
any shape or form without the express written consent of Harbor Freight Tools.
Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product described herein.
Tools required for assembly and service may not be included.
Keep this manual for the safety warnings and precautions, assembly,
Visit our website at: http://www.harborfreight.com
Email our technical support at: productsupport@harborfreight.com
®
. All rights reserved.
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.
17h
Advertisement
Related Manuals for One Stop Gardens Greenhouse 6 Ft. X 6 Ft.
Summary of Contents for One Stop Gardens Greenhouse 6 Ft. X 6 Ft.
- Page 1 Owner’s Manual & Safety Instructions Save This Manual Keep this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures. Write the product’s serial number in the back of the manual near the assembly diagram (or month and year of purchase if product has no number). Keep this manual and the receipt in a safe and dry place for future reference.
-
Page 2: Table Of Contents
Table of Contents Safety ............2 Maintenance ..........13 Specifications ..........3 Parts List and Diagram ......14 Assembly Instructions......... 4 Warranty ............ 16 WARNING SYMBOLS AND DEFINITIONS This is the safety alert symbol. It is used to alert you to potential personal injury hazards. -
Page 3: Specifications
Assembly Precautions 1. Do not assemble in windy conditions. 6. Wear ANSI-approved safety goggles and heavy-duty work gloves during assembly. 2. Assemble and install only in a flat, level area that is sheltered from the wind. 7. Keep assembly area clean and well lit. 3. -
Page 4: Assembly Instructions
Assembly Instructions Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including all text under subheadings therein before set up or use of this product. Note: For additional information regarding the parts listed in the following pages, refer to Parts List and Diagram on page 14. - Page 5 Roof Frame Assembly Note: Much of this product’s assembly is done using slip fit construction. Make sure all parts seat completely and securely. A rubber mallet (sold separately) can be used to gently tap parts in place to ensure a tight fit. Figure A: Roof Assembly Overview 1.
- Page 6 3. Assemble a roof side rail using a 3-Way Side Connector B (9), an Extension Pole (2) connected to a Joist (3), and then a 3-Way Side Connector A (8) on the far end. The combined Extension Pole / J oist assembly (2, 3) connects to the straight ends of the Connectors, and the curved ends of all Connectors must face up angled the same direction, as shown.
- Page 7 Leg Assembly Installation 1. Have assistants raise one side of the roof assembly. 2. Install two corner leg assemblies (2, 6) into the 3‑Way Side Connectors A / B (8, 9) with the Corner Legs (6) facing inward. Figure G: Leg Assembly Installation 3.
- Page 8 Bottom Rail Assembly 1. Assemble the two bottom cross rails by connecting Bottom Rail A (4) to Bottom Rail B (5). 2. Attach the combined Bottom Cross Rail assemblies (4, 5) to the Corner Legs (6) using 3‑Way Bottom Rail Clamps (10), M6 Nuts (12), M6 x 4 0 Bolts (13), and M6 Washers (14), as shown below.
- Page 9 3. Measure the width of the frame at front and back. It should be 6' wide. The distance diagonally in one direction should be equal to the distance diagonally in the other direction. If any measurements do not match, adjust the frame and retake measurements until they are equal within a reasonable tolerance.
- Page 10 Door and Back Cover Installation 1. Position the Door Cover (17) near where you want the front of the Greenhouse, and turn it so that the zipper faces the outside of the Greenhouse, and the warning tag faces inside. 2. Locate the webbed strap that runs through the hem on the Cover flaps and around the perimeter of the Cover.
- Page 11 Roof Cover Installation 1. Lay the Roof Cover (15) on the ground next to the frame. Make sure that the edges with black straps are alongside the Door/Back Covers (16, 17) with the fabric tubes facing upwards. Refer to Figure N: Roof Cover. 2.
- Page 12 Securing Ratchet Tie-Downs 1. Thread the strap through the spindle of the Ratchet Tie-Down (11) as far as it will go. Figure P: Threading Strap Through Spindle 2. Insert the S-hook of the Ratchet Tie-Down into the outside hole in the Corner Leg (6). Figure Q: Inserting Hook into Corner Leg 3.
-
Page 13: Maintenance
Maintenance Procedures not specifically explained in this manual must be performed only by a qualified technician. TO PREVENT SERIOUS INJURY FROM PRODUCT FAILURE: Do not use damaged products. If damage is noted, have the problem corrected before further use. Inspection MONTHLY, inspect the general condition of the Greenhouse. -
Page 14: Parts List And Diagram
Parts List and Diagram Parts List Note: Individual part illustrations not to scale. Part Description Illustration Part Description Illustration Rafter M6 Nut Extension Pole M6×40 Bolt Joist M6 Washer Bottom Rail A Roof Cover Bottom Rail B Back Cover Corner Leg Door Cover 3-Way Ridge Anchor... - Page 15 Assembly Diagram Item 63781 For technical questions, please call 1-888-866-5797. Page 15...
-
Page 16: Warranty
Limited 90 Day Warranty Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase.
Need help?
Do you have a question about the Greenhouse 6 Ft. X 6 Ft. and is the answer not in the manual?
Questions and answers
How can I get a replacement cover for the 6 x 6 one stop garden