Operating Instructions; Obtaining Spare Parts - EZG Mud Hog MH20 Owner's Manual

WARNING
This equipment is to be operated by trained and qualified personnel over
the age of 18. Death or serious injury can result.
1. Slide forks under the Mud Hog® and place in desired location.
2. Fully extend outriggers, set and level Mud Hog® securely on ground.
See Setup Instructions for proper procedure
WARNING
Outriggers MUST be in the fully extended position before operating.
3. Remove pins and adjust legs to desired height and reinsert pins.
See Setup Instructions for proper procedure
WARNING
NEVER put your hands inside mixer drum while equipment is running.
Death or serious injury can result.
4. Start engine.
See engine manuals for proper procedure.
5. Fill with material, add water, and mix to desired consistency and dump.
NOTE: In the unlikely event that the mixing paddles plug, momentarily reverse the paddles.
Spare parts for your Mud Hog® may be obtained by the following procedure:
1. Record the information from the serial number tag located on the frame near the hydraulic reservoir.
2. Using the parts reference table in this manual, record the part number or component.
3. Contact your local Mud Hog® dealer or EZG Manufacturing at 1-800-417-9272 with the information
recorded.
EZG Manufacturing

OPERATING INSTRUCTIONS

OBTAINING SPARE PARTS

1-800-417-9272 www.ezgmfg.com
Revision Number-011 02-23-2017 - Present
7