Page 1
INSTALLATION MANUAL Installationsmanual Bedienungsanleitung Manuel d’utilisation Manual del propietario...
Page 2
Audio Pro® , Audio Pro logotypen, är registrerade Audio Pro® , the Audio Pro logotype are all registered varumärken av Audio Pro AB, Sverige. Audio Pro Business. trademarks of Audio Pro AB, Sweden. Audio Pro Business. Alla rättigheter reserverade. Audio Pro följer ean policy om All rights reserved.
Page 3
Installation manual Installationsmanual 10-15 Bedienungsanleitung 16-21 22-27 Manuel d’utilisation 28-33 Manual del propietario...
Page 4
The VOL-1 should ideally also be placed in the same height as the TX-1 and SP-1, SP-3. • The SP-1, SP-3 and SUB-1, SUB-3 in wired mode uses a balanced audio signal so a cable with 3 conductors (+,g,-)are necessary to make the installation.
Page 5
AUDIO PRO BUSINESS UNITS This is an overall general description of the Audio Pro Business units. For product specifications of the products please see the specific user manual that comes with each of the products. SP-1, SP-3 WIRELESS LOUDSPEAKER Equipped with the GLOBAL trac Multi adapter GA 69 which suits almost every 3-phase tracks on the market.
PRESS PAIR ON TX-1. (It stays in pair mode in 20 minutes after last paired unit) 3. PRESS PAIR ON ALL UNITS YOU WANT TO PAIR. 4. SET VOLUME ZONE "A" TO "F" ON EACH SPEAKERS. (if desired, otherwise keep same Volume Zone on all speakers) SP-1, SP-3 SUB-1, SUB-3 VOL-1 TX-1...
Page 7
• Place VOL-1 as high as possible. • Secure SP-1, SP-2 in tracks (or on wall using wallbracket), preferably on same height as TX-1. • Place SUB-1, SUB-2 on wall using wallbracket, preferably on same height as TX-1. 6. CONNECT TX-1 TRANSMITTER TO A SOUND SOURCE •...
Page 8
• When set to WIRED input, volume level on wired speaker can be adjusted -20 dB to +20 dB to fine tune volume levels on that specific speaker. REAR OF SUB-1, SUB-3 1. Wireless / Wired input switch 2. Line in, + / Ground / - 3. Line out, + / Ground / - REAR OF SP-1, SP-3...
Page 9
TROUBLESHOOTING - IF YOU HAVE PERFORMANCE ISSUES HOW FAR APART ARE THE TRANSMITTER AND RECEIVER? If distance between the transmitter and receiver is too far, the, connection might be lost. Try placing the transmitter and receiver in closer proximity. ARE THERE WALLS BETWEEN THE TRANSMITTER AND LOUDSPEAKERS? If your premises has thick concrete walls, or walls of plaster with wire lath, the wireless range will decrease.