Do you have a question about the F-12 and is the answer not in the manual?
Questions and answers
Greg Stott
March 14, 2025
I have an old stereo, does the subs crossover also impact the high level outputs? If you set the crossover @80hz for the sub, are the high level outputs limited to the range above 80hz?
1 comments:
Mr. Anderson
May 14, 2025
No. The Formula F-12 subwoofer’s crossover setting at 80Hz does not limit the high-level outputs to frequencies above 80Hz. The crossover frequency control does not affect the signal when using digital receiver modes such as 5.1, 6.1, or 7.1.
This answer is automatically generated
Subscribe to Our Youtube Channel
Summary of Contents for Formula F-12
Page 1
Company OWNER’S MANUAL Model F-12 12˝ Powered Subwoofer SPECIFICATIONS Woofer Size 12˝ Injection-Molded Long Throw Woofer Power 475 Watts Dynamic Peak Output (150 Watts RMS Continuous) MAX Acoustic Output 115 dB SPL Frequency Response 25Hz - 200Hz (+/- 3dB) Crossover Frequency Range...
Page 2
A. Sub’s amp power-supply cord or the plug F-12 AMPLIFIER PANEL TOUR ..3 in a wet basement or near a swimming pool. has been damaged; or PLACEMENT .
After you’ve hooked up process. This procedure is not difficult, but of the F-12, as shown in Drawing 1. your subwoofer, you’ll discover just how it IS slightly different than setting up a line .
Page 4
11. OUT TO SPEAKERS. If you are using areas where bass is either exaggerated or anywhere in a normal-sized room. the F-12 from receiver inputs, you will hook reduced. your main speakers to these binding post, Incidentally, moving the subwoofer around 4.
On that end, on the lower right-hand corner, you’ll see two small stereo components. jumper connectors. Instead, connect the F-12 to its own AC Move the connectors. There are four pairs of pins onto which the jumpers can be placed. outlet ONLY. See items 8 and 9 in the Safety For 120-volt operation the jumpers are placed on the two outer pairs of pins.
Page 6
Method B: Amplifier wiring hookup steps for receivers RECEIVER OR INTEGRATED AMPLIFIER or surround sound receivers with NO sub output jack FRONT SPEAKERS LEFT RIGHT See Drawing 4 1. IMPORTANT: Make sure that ALL stereo system components including the subwoofer are turned OFF before proceeding.
If you don’t hear bass by the time you have advanced the subwoofer’s • confirm that the power amplifier is The F-12 enclosure is finished in a very VOLUME control halfway, turn off the sys- turned on. high quality polymer laminate covering that tem and check connections.
Page 8
B . I . C America reserves the right to revise its FITNESS FOR USE OR SUITABILITY OF THE Speaker Systems specifications without notice. B . I . C/FORMULA ELECTRONIC PRODUCT. B . I . C America 925 N. Shepard Street Anaheim, CA 92806 www.bicamerica.com...
Need help?
Do you have a question about the F-12 and is the answer not in the manual?
Questions and answers
I have an old stereo, does the subs crossover also impact the high level outputs? If you set the crossover @80hz for the sub, are the high level outputs limited to the range above 80hz?
No. The Formula F-12 subwoofer’s crossover setting at 80Hz does not limit the high-level outputs to frequencies above 80Hz. The crossover frequency control does not affect the signal when using digital receiver modes such as 5.1, 6.1, or 7.1.
This answer is automatically generated