Operation • Bright-time is a waterproof, 4 channel, real time clock • Each channel may be programmed with up to 8 timing entries • The timing entries may be programmed to operate in a continuous ‘TIMED’ mode or a pulsed ‘CYCLIC’ mode •...
Installation Diagram NO C GND NO C GND NO C GND NO C GND ~230V NO C GND NO C GND NO C GND NO C GND...
Page 4
With the links in place, the relevant outputs will supply 24V DC Channel 1 - LK1 & LK2 Channel 2 - LK3 & LK4 Channel 3 - LK5 & LK6 Channel 4 - LK7 & LK8 G756-3 BRIGHTWELL DISPENSERS Links in place L N E NO C GND NO C GND...
Page 5
Channel 1 - LK1 & LK2 Channel 2 - LK3 & LK4 Channel 3 - LK5 & LK6 Channel 4 - LK7 & LK8 G756-3 BRIGHTWELL DISPENSERS Links removed L N E NO C GND NO C GND...
Programming Instructions BRIGHTWELL Channel 1 Wednesday Channel 2 14:52:02 Channel 3 Tel:+44 1273 513566 Channel 4 Shown above are the default screens available when in operating mode. Either screen can be selected using the + and - keys. The second screen shows the current state of each channel.
Page 7
Program channel, Clear timing entries and Set up system options will require a PIN number before allowing access. When selecting one of these options, the following screen will be displayed. Use the + and - key to enter your 4 digit access code and PROGRAM MODE press the ACCEPT key to move on.
Page 8
Channel/Entry Number Mode; TIMED (Continuous); Operational Days CYCLIC (Pulsed) Edit TIMED Start time; HRS:MIN START M------ 00:00 DURATION 00:00:00 Run duration; HRS:MIN:SEC • Using the + and - keys, select the mode that you wish the channel entry to operate in, TIMED or CYCLIC •...
Page 9
Clearing Timing Entries (access code protected) PROGRAM MODE Using the + and - keys, select the Channel that you wish Clear timing entries Channel 1 to clear. PROGRAM MODE Press ACCEPT to clear ALL the timing entries of the Clear timing entries Channel 1 chosen channel.
Page 10
Viewing Total run time PROGRAM MODE Using the + and - keys, select the Channel that you wish View total time Channel 1 to view the total run time of. CHANNEL 1 TOTAL TIME The total run time will be displayed along with the date SINCE --/--/-- --:-- =----Hrs --min --sec and time that it was last reset.
Page 11
ON, then it will be switched OFF and if the channels is OFF, then it will be switched ON. An OVER-RIDDEN channel will only remain in this state until the next programmed ON/ OFF time. The OVER-RIDE feature only works from the default screens. BRIGHTWELL Press the OVER-RIDE key to enter the OVER-RIDE Wednesday menu. 14:52:02...