Do you have a question about the Premier Elite ComGSM and is the answer not in the manual?
Questions and answers
Summary of Contents for Texecom Premier Elite ComGSM
Page 1
Installation Manual Premier Elite ComGSM INS315-4...
Page 2
Premier Elite Com GSM Module Installation Manual 1. Introduction The Premier Elite Com GSM is a 2G module that can be connected to any Premier or Premier Elite control panel; however functionality differs depending on the type of Premier panel installed and the type of SIM card that is used.
Page 3
SIM cards purchase Texecom DO NOT supply SIM cards. These will need to be sourced locally, and care should be taken to source SIM cards in the country where the unit is to be used. This will help reduce costs and avoid excessive data charges.
Page 4
Premier Elite Com GSM Module Installation Manual Mounting the ComGSM R emove the screw cover by locating the two small indents on the upper and lower edge with a s mall s crewdriver. E xcess ive force is not required. R emove the retaining screw If removal from mounting tamper detection is required, the housing MUS T be fixed at this point.
Page 5
Com1 data connection to Premier control panel Tamper switch (Lid and off the wall tamper when fixed correctly) Engineer keypad connector ( only used to power the Premier Elite ComGSM when using APNProgrammer Status LED’s (see table below) Tamper Switch connector...
Page 6
Premier Elite Com GSM Module Installation Manual Option Switches The option switches [8] function as follows: Switch Function GSM will communicate and will report GSM will communicate and will NOT report Tamper Comms lid & off the wall tampers. tampers from the unit.. Accepts connections on port 10001 and allows GPRS server Normal GSM operation...
The SIM card must be inserted before connecting the Premier Elite ComGSM module to the control panel, and must not be removed until after the power supply to the Premier Elite ComGSM module has been deactivated. Set the option switches as required, see page 6.
3 is off or flashing, this indicates a low GSM signal level. If the signal level is low, try moving the antenna to improve the reception. Using the SMS Control Commands Control commands can be sent to the Premier Elite ComGSM module to allow remote control and interrogation of the alarm system. Select the send text message option on your mobile telephone.
Page 9
Premier Elite Com GSM Module Installation Manual Premier 24 SMS Control Commands Operation Command Example Arm System ???? arm [s] “5678 arm s” = arm the system and report back status. Part Arm System ???? parm (1/2/3) [s] “5678 parm 1” = part arm 1 the system (no status) Disarm System ???? darm [s] “5678 darm”...
Page 10
Premier Elite Com GSM Module Installation Manual What will be sent in the Text Message The following information will be received in the text message: My Home N a m e p r o g r a m m e d i n t o p h o n e 3 W e s t e r n R o a d U p t o 1 6 c h a r a c t e r s o f t e x t ( t h i s i s t h e P r i n t e r H e a d e r ) 1 2 : 4 5 .
All Texecom products are designed for reliable, trouble-free operation. Quality is carefully monitored by extensive computerised testing. As a result the Premier Elite ComGSM module is covered by a two-year warranty against defects in material or workmanship. As the Premier Elite ComGSM module is not a complete alarm system but only a part thereof, Texecom cannot accept responsibility or liability for any damages whatsoever based on a claim that the Premier Elite ComGSM module failed to function correctly.
Need help?
Do you have a question about the Premier Elite ComGSM and is the answer not in the manual?
Questions and answers