Page 1
Operating Manual ORTNER ST11 42/59 Manual and automatic operation Before the commissioning of the firing installation, the operating manual must be read; disregard of the instructions will lead to the voiding of the manufacturer’s warranty. The respective national or local regulations and general provisions and codes of practice must be complied with! Do NOT use this firing installation as a waste incinerator.
Page 2
ORTNER GmbH | Hürmer Straße 36 in A-3382 Loosdorf | Tel +43 2754 2707 | Fax +43 2754 2708 office@ortner-cc.at | www.ortner-cc.at...
A large amount of ash is generated: ..........................9 Following combustion, a large amount of black charcoal remains in the firebox: ............9 ORTNER GmbH | Hürmer Straße 36 in A-3382 Loosdorf | Tel +43 2754 2707 | Fax +43 2754 2708 office@ortner-cc.at | www.ortner-cc.at...
Table of the measured emission values in accordance with EN 13229: Dust (mg/MY) (mg/MY) (mg/MY) (mg/MY) >80 ORTNER GmbH | Hürmer Straße 36 in A-3382 Loosdorf | Tel +43 2754 2707 | Fax +43 2754 2708 office@ortner-cc.at | www.ortner-cc.at...
Mean required discharge pressure with rated heat output 14 Pa Stack gas mass flow: 43 g/s Total mass (without KMS): approx. 455 kg ORTNER GmbH | Hürmer Straße 36 in A-3382 Loosdorf | Tel +43 2754 2707 | Fax +43 2754 2708 office@ortner-cc.at | www.ortner-cc.at...
When pressing the door lever down, pay attention to the engagement of the lock. Only a correctly locked combustion chamber door ensures a secure combustion. ORTNER GmbH | Hürmer Straße 36 in A-3382 Loosdorf | Tel +43 2754 2707 | Fax +43 2754 2708 office@ortner-cc.at | www.ortner-cc.at...
Repeat this process 2 to 3 times. ORTNER GmbH | Hürmer Straße 36 in A-3382 Loosdorf | Tel +43 2754 2707 | Fax +43 2754 2708 office@ortner-cc.at | www.ortner-cc.at...
/ breakage of the firebox lining occurs without mechanical external influence (e.g. throwing in the logs, …). ORTNER GmbH | Hürmer Straße 36 in A-3382 Loosdorf | Tel +43 2754 2707 | Fax +43 2754 2708 office@ortner-cc.at | www.ortner-cc.at...
Check the quality of the wood (moisture, dirt content) or you are using an insufficient amount of wood per firing instance. ORTNER GmbH | Hürmer Straße 36 in A-3382 Loosdorf | Tel +43 2754 2707 | Fax +43 2754 2708 office@ortner-cc.at | www.ortner-cc.at...
Page 11
ORTNER GmbH | Hürmer Straße 36 in A-3382 Loosdorf | Tel +43 2754 2707 | Fax +43 2754 2708 office@ortner-cc.at | www.ortner-cc.at...
Need help?
Do you have a question about the ST11 42/59 and is the answer not in the manual?
Questions and answers