Icom RMK-2 Instruction

SEPARATION KIT
RMK-2
I Supplied accessories
Main unit attachment
Front panel attachment and bolts (M3×15)
I Separation
CAUTION! To avoid damage to the transceiver, turn the
power OFF before separating from the main unit.
The optional OPC-607
(3 m; 9.84 ft)
OPC-609*
(1.9 m; 6.3 ft)
SEPARATION CABLE
stalling the transceiver front panel and main unit separately.
*For Europe version, only the OPC-609 is available.
q Turn the transceiver's power OFF, then disconnect the DC
power cable.
w Unscrew the 4 bottom screws, then remove the bottom
cover from the transceiver in the direction of the arrow.
e Disconnect the flat cable and speaker cable* from the
main unit.
Speaker cable*
*Depending on version
INSTRUCTIONS
Mounting bracket
Flat cable
, OPC-608 or
(8 m; 26.3 ft)
is required for in-
Bottom cover
Flat cable
Thank you for purchasing the
The RMK-2 allows you to install the IC-F1700 series
transceiver front panel separately from the main unit
for added installation convenience and operation.
Use either the optional OPC-607, OPC-608 or OPC-
609 with the RMK-2.
SEPARATION CABLE
Flat washers
(M5)
Spring washers
(M5)
Nuts (M5)
r Unscrew the 2 side screws, then remove the front panel
from the transceiver main unit in the direction of the arrow.
t Unscrew the 4 screws, then remove the rear plates from
both the front panel and main unit attachments.
*This illustration shows
the description for the
front panel attachment.
Rear plate
Icom, Icom Inc. and the logo are registered trademarks of Icom Incor-
porated (Japan) in the United States, the United Kingdom, Germany, France,
Spain, Russia and/or other countries.
RMK-2 .
SEPARATION KIT
Mounting screws
(M5×12)
Self-tapping screws
(M5×16)
Bracket screws
Main unit
Front panel
Unscrew the cir-
cuit board screw.
Continue to the back page.