Harbor Freight Tools VULCAN MIG GUN LINER Owner's Manual & Safety Instructions

0.025"-0.045"

Download this manual

Owner's Manual & Safety Instructions

Save This Manual

operating, inspection, maintenance and cleaning procedures. Write the product's serial number in the

back of the manual near the assembly diagram (or month and year of purchase if product has no number).

Keep this manual and the receipt in a safe and dry place for future reference.

When unpacking, make sure that the product is intact

and undamaged. If any parts are missing or broken,

please call 1-888-866-5797 as soon as possible.

2017 by Harbor Freight Tools

No portion of this manual or any artwork contained herein may be reproduced in

any shape or form without the express written consent of Harbor Freight Tools.

Diagrams within this manual may not be drawn proportionally. Due to continuing

improvements, actual product may differ slightly from the product

described herein. Tools required for assembly and service may not be included.

Keep this manual for the safety warnings and precautions, assembly,

Visit our website at: http://www.harborfreight.com

Email our technical support at: productsupport@harborfreight.com

Read this material before using this

product. Failure to do so can result in

serious injury. SAVE THIS MANUAL.

17e

Need help?

Do you have a question about the VULCAN MIG GUN LINER and is the answer not in the manual?

Page 1 No portion of this manual or any artwork contained herein may be reproduced in product. Failure to do so can result in any shape or form without the express written consent of Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing serious injury.
Page 2 IMPORTANT SAFETY INFORMATION 1. Disconnect welder power and discharge 6. Do not install when tired or when under the electrode to ground before installing. influence of alcohol, drugs or medication. 2. Install only according to these instructions. 7. This product is not a toy. Do not allow Improper installation can create hazards.
Page 3 8. Lay out the old and new Liners flat next to each 11. Reassemble the MIG Gun and other. Line up the plug ends of the Liners with one connect it to the Welder. another. Trim off the plain end of the new Liner even with the other liner.
Page 4 Limited 90 Day Warranty Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase. This...