Configuring The Utred30-Wifi For Logging - LogTag Recorders UTRED30-WiFi Product User Manual

Preparing a UTRED30-WiFi for first use

Configuring the UTRED30-WiFi for logging

Before a UTRED30-WiFi logger can be used, it must be configured with the parameters required for
starting and recording temperature values
l
triggering alarms
l
connecting to the local WiFi network
l
connecting to your cloud account
l
This is done using LogTag
®
LogTag Analyzer includes the LogTag
and network settings and register the UTRED30-WiFi against your LogTag
Start the LogTag
l
Remove the protective cap from the logger's USB socket and plug the Micro USB end of the cable
l
into the socket. Plug the other end of the cable into a USB socket on your computer and wait for the
drivers to be installed
Slot the logger into the interface, contacts facing down and towards the rear of the interface.
l
From the menu click LogTag - Configure; LogTag
l
connected loggers.
Standard Configuration Settings
The standard configuration is similar to those of other LogTag
as User ID, start method,
Adjust the settings as required. For detailed information about each parameter please read the section
about Configuring a LogTag
1
You can configure more than one UTRED30-WiFi at the same time, however it is practical to limit the number of units to about 6, using a powered
USB hub.
UTRED30-WiFi User Guide
®
Analyzer software, which can also be used for downloading and analyzing data.
®
Online Connection Wizard, which will allow you to set wireless
®
Analyzer software.
1
.
pre-start recording, logging interval
®
for logging in LogTag
®
Analyzer will display the configuration options for
®
logger products and includes settings such
and duration,
®
Analyzer's User Guide or press F1 for help.
®
Online account.
start delay, and password.
10