Advertisement
CowboyStudio FA 160B Flash Lighting Kit Use Instructions
1.
Before using the light, make sure that the electrical outlet of your local power supplier matches the
power regulation indicated on your lighting equipment.
2.
Do not use any power supply other than the AC specification indicated on your equipment.
3.
Do not expose your lighting equipment to sunshine, moisture, dust, dirt, rain, or water.
4.
Any exposure to chemical solutions, gasoline, grease, oil, paint, or detergents can result in
permanent damage to your equipment.
5.
Do not insert metal parts into any lighting equipment.
6.
Dry your hands before handling the equipment, as touching your equipment with wet hands is
dangerous to both of the equipment and to you.
7.
Do not keep the power on when the light is not in use.
8.
Do not attempt to repair your lighting equipment without the companion of the well trained
technician.
1.
To keep the internal surface of the reflector clean, wipe off the dust with a soft cloth after turning
the power off.
2.
Turn the power off and store your equipment in a dry place when it is not in use.
MT-160 is a quality strobe light with an exceptional value for commercial studios, location
photographers, photo schools, students and amateurs as well. The MT-160 not only contains all of the
fundamental features. Designs for MT-160 (i.e. color-temperature corrected circle flash-tube, fixed
reflector and power cable, remote sensor/slave, built-in umbrella holder, and angle-adjustable fixture),
but also includes some professional functions such as continuous power adjustor with fine-setting
clutches, dual-locking stand adapter. It features with stable color temperature (5600K), large
lighting-coverage and even lighting effect.
Power Input: AC220 volt,
50/60Hz
Flash-tube Lifetime: over 8,000 typical flashing
Power Setting: 1/16 to full
continuously
Flashing Duration: 1/600 sec. @t=0.1; 1/1000 sec. @t=0.5
Lighting Range: 55
degree
Synch Voltage: 6volt
Safety Precautions
Tips for Use
Introduction
Specification
Flash Power: 160ws (joule) in full
Color Temperature: 5600K
Modeling Power: Halogen 75w
Dimension:φ4"×7-1/2"(φ100mm×195mm)
mono160
Recharge Time: 0.5-3
seconds in full.
Fuse: 5A
Guide No.: 120ft/36m
ISO100
Slave Effectiveness: 10m;
35ft
Bulb Base: E-14 screw
Weight: 1.8Lb (800g)
Advertisement
Table of Contents
Summary of Contents for CowboyStudio FAN160B
- Page 1 CowboyStudio FA 160B Flash Lighting Kit Use Instructions Safety Precautions Before using the light, make sure that the electrical outlet of your local power supplier matches the power regulation indicated on your lighting equipment. Do not use any power supply other than the AC specification indicated on your equipment.
-
Page 2: Control Panel
Control Panel Indicator: power supply Synch cord base Test button: flash Indicator: recharge ready Output power setting: flash 10. Umbrella holder Slave sensor & modeling bulb 11. Angle adjustable handle General Power on/off switch On/off switch:modeling 12. Stand Mounting Bolt Safety fuse bulb Operation... - Page 3 Choose different power setting with key (7) for different exposures. Link your MT-160 with your camera by means of synch cord or use the built-in slave sensor to trigger the light. Pushing the key (9) to the right, audio signal will remind you when recharge of power is in full. Audio signal function becomes inactive by moving back the key (9) to the left.
Need help?
Do you have a question about the FAN160B and is the answer not in the manual?
Questions and answers