Advertisement
Please read the following before proceeding with installation
and operation of the JohnDow Used Oil Storage System.
Installation:
1. Position the tank in a location that is within 2" of level.
2. Attach the 10' x 3/4" intake hose to the pump.
3. Install the liquid level gauge in the 2" coupling at the left
read of the tank according to the instructions provided
with the gauge.
4. If required by local regulations, install necessary venting
through the 4" coupling located at the center of the tank.
5. Install the hose hanger by bolting it on the outside of the
tank.
6. Attach air supply to the connection on the rear of the
security cabinet.
7. Install quick disconnect adapter to waste oil drain.
Operation:
1. Position the full waste oil drain next to the system and
connect the intake hose to the drain.
2. Open the valve on the waste oil drain assembly.
3. Turn on the air supply to start the pump and transfer of
used oil
4. When the oil drain is empty - disconnect the hose and
then turn off the air supply.
Before attempting to transfer oil, always check the tank level
to determine if sufficient capacity is available. This will pre-
vent possible overfilling of the tank. Call your authorized
used oil hauler to evacuate the tank.
Assembly Instructions
CAUTION:
Advertisement
