Advertisement
Quick Links
6030SPANL/R, 6030SPANML/R, 6030STUBL/R, 6030STUBML/R
Read and follow all instructions prior to installing your Aquatic Bath fixture. Save these instructions for future reference. Failure to comply with these
instructions may invalidate your warranty. For questions concerning installation and maintenance of your Aquatic Bath shower or tub/shower,
contact Technical Services at 800-945-2726.
Tools Needed
3/16"
Drill Bit
Phillips Screw Bit
Items Included
6030SPAN
Included – Shower Pan or Tub
NOTICE: Please inspect the unit thoroughly before installation to make sure it has not been damaged during transportation.
Under no circumstances should a damaged unit be installed. Neither Aquatic Bath nor the distributor will be responsible for
removal or reinstallation costs should a replacement be necessary due to installation of a damaged unit.
Installation Data
Customer Service: 800-945-2726
6030STUB
— 1 —
Advertisement
Related Manuals for Aquatic 6030SPANL/R
Summary of Contents for Aquatic 6030SPANL/R
- Page 1 6030SPANL/R, 6030SPANML/R, 6030STUBL/R, 6030STUBML/R Read and follow all instructions prior to installing your Aquatic Bath fixture. Save these instructions for future reference. Failure to comply with these instructions may invalidate your warranty. For questions concerning installation and maintenance of your Aquatic Bath shower or tub/shower, contact Technical Services at 800-945-2726.
- Page 2 Pre-Installation Planning *Please read ALL installation instructions completely before beginning. 1. Review job print and Aquatic rough-in dimensions; verify all key 7. Tubs require a 6” x 12” floor opening for the 2” IPS drain connection (See diagram 1 for location). Shower pans require a dimensions against actual job conditions.
-
Page 3: Installation Instructions
Installation Data 6030SPANL/R, 6030SPANML/R, 6030STUBL/R, 6030STUBML/R Remove base. Measure the distance between the top of the back horizontal flange and the bottom of the pan ledge, approximately 1-1/2”. Mark this dimension on the back studs (or wall), below the first mark. - Page 4 Do not allow solvent to go down the drain. Make powders or pads, steel wool, scrapers, sandpaper sure not to contact plastic drain grates or other synthetic or anything else that could scratch or dull the surface of your Aquatic materials. unit. Instead, use warm water and liquid detergents 5.