Kudo3D Bean User Manual page 11

Note: If you would like to understand other basic functions of Meshmixer, please refer to
https://www.youtube.com/playlist?list=PLu8TYSQ5jCFjdQBHsLoybhdKXOTmpTRlb
4. Support generation:
There are two options. You can use the Meshmixer or you can purchase Kudo3D model
preparation software. The trial version will be released in a few weeks and there will be a separate
manual for our own software.
If you want to use Meshmixer for support generation, please visit
https://www.youtube.com/watch?v=aFTyTV3wwsE
Supports are required for the following circumstances:

All downward facing tips or hills on the model

Overhanging region
- distance between two supports depends on the overhanging slope

Internal supports
- to counteract the non-uniform shrinkage caused by the structure, such as a box with no lid

To counteract the non-uniformity of intensity and higher separation force close to the anchoring
side of the vat, thicker or denser supports might be necessary.

To isolate the bulk shrinkage and avoid detachment from the build platform.
Before adding supports, please raise the model 5mm above the floor to leave rooms for the supports.
The purpose of lifting the model is twofold.

Supports absorb the shrinkage of the model to prevent warping of the base so the model is less
likely to drop from the platform.
Kudo3D Bean User Manual
Ver. 1.0
11 of 14