Turning The Unit On; Select The Function; Care And Cleaning - Morphy Richards 172251 Instruction Book

Coffee maker with milk frother
Table of Contents

Advertisement

CM172251MMY Rev1.qxp_Morphy Richards - Instruction Book 18/08/2017 16:13 Page 5
Caffé Barista Ratios
Espresso
Single
Double
Cappuccino
Single
Double
Latte
Single
Double

Turning the unit on

1
Make sure unit is plugged in.
2
Turn unit on (11). The three control panel lights will start flashing
until the water reaches temperature. When the lights become solid,
the unit is ready to use.

Select the function

Preparing espresso
a
Press the Espresso Button (4) once to brew one single shot.
b
Press the Espresso Button (4) twice to brew a double shot.
c
Press and hold the Espresso Button for 3 seconds to increase the
quantity of coffee dispensed according to personal preference.
The unit will turn off automatically and the lights will become solid
indicating that the cycle has been completed.
NOTE: To brew less coffee than the pre-set serving, press the
function button to stop the brewing process when the amount of
coffee desired is reached.
Preparing cappuccino
Prior to preparing your cappuccino, adjust the quantity of frothed
milk according to your preference by turning the Froth Control
Knob (14) to the right for more foam and to the left for less foam.
Note: The foam intensity can be adjusted during the brewing cycle.
a
Press the Cappuccino Button (5) once to brew a small cup of
cappuccino.
b
Press the Cappuccino Button twice to brew a large cup of
cappuccino.
The unit will start brewing the cappuccino according to your
selection.
Preparing Latte
Prior to preparing your latte, adjust the quantity of frothed milk
according to your preference by turning the Froth Control Knob
(14) to the right for more foam and to the left for less foam.
a
Press the Latte Button (6) once to brew a small cup of latte.
b
Press the Latte Button twice to brew a large cup of latte.
Preparing frothed milk
The unit also allows you to froth milk only. Press and hold the
Cappuccino Button (5) for 3 seconds if you wish to add more foam
to your beverage or to prepare frothed milk for any other beverage,
e.g. macchiato, hot chocolate, chai latte etc. When finished, press
the Cappuccino Button again to stop.
60ml
(2oz)
119ml
(4oz)
178ml
(6oz)
355ml
(12oz)
296ml
(10oz)
474ml
(16oz)
1
2
3
4
5
6
7
1
2
3
4
5
After preparing your beverages with milk 7
When you have finished preparing your beverage with milk, you
can either store the milk reservoir directly in the refrigerator or
dispose of the leftover milk.
Espresso
A unique method of coffee brewing in which hot water is forced
through finely ground coffee. Because of its richness, espresso is
usually served in 44 to 59 ml (1.5 to 2 oz.) portions, in demitasse
cups.
Cappuccino
A drink made with about 1/3 espresso, 1/3 steamed milk, and
1/3 frothed milk.
Latte
A drink made with about 1/4 espresso and 3/4 steamed milk.

Care and Cleaning

It is important to clean the milk tank and frothing tube
regularly to avoid clogging.
To clean the milk tank:
Remove the milk tank from the unit
Remove the lid of the tank.
Pour away any milk in the tank and rinse the milk reservoir and its
lid thoroughly with warm soapy water. Rinse and dry well.
Place a large empty cup under the frothing tube ensuring the end
of the tube is inside the cup.
Fill the milk tank with water.
Press and hold the Latte/clean button for 3 seconds and then
release it. Turn froth nozzle to 'Clean'. The unit will start to release
steam through the frothing tube, let it run for a few seconds until
the steam / water runs clear. When completed the Latte/ clean
button can be pressed once to stop the process or allow to auto
stop.
Dispose any water left in the milk tank and place it back in the
unit.
Note: Do not use abrasive cleaners and scouring pads. The milk
tank is dishwasher safe (top rack). The lid of the milk tank is NOT
dishwasher safe.
Cleaning the brew head, filter holder and filter
Remove the filter holder and discard the coffee grounds or used
pod. Wash both the filter holder and filter with warm soapy water
and rinse well.
Wipe lower part of the brew head inside the unit with a damp cloth
or paper towel to remove any coffee grounds.
Place the filter holder (without a filter) back into the brew head
attaching securely.
Place an empty large cup under filter holder.
Press the espresso button once and let the unit brew with water
only until it stops automatically.
Caution: Some of the metal parts may still be hot.
Note: The filter holder and the filters are NOT dishwasher safe.
g
5

Advertisement

Table of Contents
loading

Table of Contents