Advertisement
Table of Contents
Installation and Operating Instructions for the iAdapter-Mini™ 2 & 4
Loosen the 8 (eight) screws from the back of the
iAdapter™ as shown in the picture below. These
screws are captive screws and will not fall out
after you loosen them and turn the bottom
housing over.
Place the iPad™ onto the 6 (six) rubber supports
inside the iAdapter™. The rubber supports are
color coded for the different iPad's. RED is for
iPad Mini versions 1 through 3. BLACK is for the
iPad Mini 4.
Make sure that the reset button of the iPad®
lines up with the reset button of the iAdapter™
as shown in the picture to the right.
Place the top housing of the iAdapter™ over the
iPad®. Align the top housing of the iAdapter™
with the bottom housing of the iAdapter™.
Carefully hold both the top and the bottom
housing of the iAdapter™ together and then turn
it over onto a flat surface. Tighten the 8 (eight)
screws that will hold the iAdapter™ together.
Designed by AMDi
www.amdi.net
Advertisement
Table of Contents
Related Manuals for Amdi iAdapter-Mini 2
Summary of Contents for Amdi iAdapter-Mini 2
- Page 1 Carefully hold both the top and the bottom housing of the iAdapter™ together and then turn it over onto a flat surface. Tighten the 8 (eight) screws that will hold the iAdapter™ together. Designed by AMDi www.amdi.net...
- Page 2 Charger LED on the iAdapter changes to GREEN the battery is fully charged. It is recommended that you slide the Power switch to the OFF position while charging the battery of the iAdapter. USB Cable USB Charger Designed by AMDi www.amdi.net...
Need help?
Do you have a question about the iAdapter-Mini 2 and is the answer not in the manual?
Questions and answers