Table of Contents
Advertisement
CAUTION: This sprayer is constructed out of Polypropylene, Rubber, Aluminum and
Steel. Check the manufacturer's compatibility list of any material you want to spray
before using that material in this sprayer. Some materials may damage
polypropylene, rubber, aluminum or steel.
WARNING: This sprayer will create a mist or spray of whatever material is being
used. This spray may be breathed in or over-sprayed on plants, animals, property,
children or other bystanders. Use precautions to prevent breathing the sprayed
material and to avoid over-spray. Cover plants or materials that may be damaged
by over-spray. Keep children, animals and bystanders out of the area during
operation.
1.
Be sure the Main Tank (27), Pump Assembly (28), Tube and Wand Assembly
(1-19) are all clean and dry before use.
2.
Prepare the spray material according to manufacturer's directions. Use
caution to prepare for safely spraying.
3.
Open the Main Tank by turning the Pump Assembly (28) counterclockwise.
Locking Ring (34) will unscrew out of the Main Tank (27).
4.
Pour the prepared mixture (not included) into the Main Tank (27). Do not
overfill. Do not fill beyond the "FULL" mark on the Main Tank. This sprayer
requires some open space for pressurized air above the mixture, to operate
properly.
5.
Screw the Pump Assembly back into the Main Tank. The Locking Ring (34)
must make a good seal into the Main Tank (27).
6.
Pressurize the tank by moving the Pump Handle (33) up and down several
times. As pressure builds in the tank, you will feel increased resistance while
pumping. While pumping, be sure the Pump Rod (40) moves directly up and
down in line with the Pump Assembly (28). Do not bind or bend the Pump
Rod.
7.
Do not over-pressurize the Main Tank (27). You will learn by experience how
much pressure is enough. Too much pressure will result in the Pump
Assembly being very hard to operate, the Pressure Relief Valve (31) may open
releasing pressure or the O-Ring (35) may fail. Too little pressure will result in
the sprayer not spraying effectively.
8.
When done pumping, press the Pump Handle (33) down and turn clockwise to
lock it in place in the Locking Ring (34).
9.
To spray, hold the Handle (13) in your hand. Squeeze the Trigger and begin
spraying. Move the spray over the desired area. When done, release the
Trigger and spraying will stop.
For technical questions please call 1-800-444-3353 Page 5
SKU 95143
Operation
Advertisement
Table of Contents
