Summary of Contents for D-MOO SV-040(6M+H)
- Page 1 Pedicure Spa (Footspa) Owners’ Manual Model: SV-040(6M+H） Basin: 8169 Manufactured Date：March, 2018 Serial Number ： Installation Date：...
- Page 2 Introduction ---------------------------------------------------------------------------------- We sincerely thank you for purchasing our pedicure spa ( footspa )on the market ! This innovative whirlpool footspa has been designed to service your clients from head to toe dependably. Please take time to read through this entire manual before installation and use.
- Page 3 Important Installation Considerations ---------------------------------------------- Electrical Service Check the voltage first and install a leak current breaker by a licensed electrician to ensure the safety operation. Each footspa must have its own dedicated 230V, 60 Hz /15 Amp GFCI protected grounded circuit . Water Supply Water supply to the foot spa should consist of a system that will provide both adequate water pressure and water temperature.
- Page 4 Step 2 ：Attaching Chair with Base Your Footspa is shipped with base and chair already attached at separate carton box. However, you must install the chair on the base using the Must sure that you fasten the chair with base supplied nut.
- Page 5 TO Start and OFF ： Press the switch ON/OFF on the front panel. IMPORTANT : DO NOT turn the Footspa “ ON” unless adequate water is in the tub. THE WARRANTY IS VOLD WHEN THE PUMP HAS BEEN RUN WITHOUT ADEQUATE WATER. DO NOT BLOCK THE JETS DURING WHIRLPOOL OPERATION.
- Page 6 Limited Warranty ---------------------------------------------------------------------------- We manufacture the Footspa under high standards of workmanship and with high quality materials. According our expressly warrant the footspa as below: TO the original owner of the footspa . We may repair or exchange at its option, any Footspa found to be defective in material or workmanship upon inspection by our authorized distributor.
- Page 7 Instruction of Assemble Suit the holes of chair arm to the metal frame at the bottom of chair seat then lock it by enclosed tool Suit the holes of swivel to the metal frame at the bottom of chair seat then lock it by enclosed tool.
- Page 8 Specification For Functional Massage System L082 1. POWER SWITCH: Press once, power on. Press again, power off. The power will be shut down after times up. 2. ZONE SWITCH: Seven massage programs for different position could be chosen and the eighth pattern will stop all functions. LED flash change as follow: M1->M2->M3->M1+M2->M2+M3->M1+M3->M1+M2+M3.
Need help?
Do you have a question about the SV-040(6M+H) and is the answer not in the manual?
Questions and answers