Related Manuals for Light & Motion TRV120
Summary of Contents for Light & Motion TRV120
- Page 1 O w n e r ’ s M a n u a l For Sony TRV30, TRV730, TRV530, TRV330 and TRV120 Camcorders www.uwimaging.com...
- Page 2 Never leave your housing in the rinse bucket, it may be damaged by other equipment. • When removing the camcorder from the housing after a dive, do so in a dry controlled environment away from other SCUBA related equipment. This prevents water from other equipment or water from another diver accidentally entering the housing.
-
Page 3: Getting Started
Take time to familiarize yourself with the housing. Camera Preparation Install the appropriate fully charged Sony camcorder battery. Install a Sony MiniDV tape or Digital8 tape into your camcorder. Install a Memory Stick in your camcorder Mounting the Camera Remove the rear plate by simultaneously rotating both latches down and rearward of the housing body. -
Page 4: Operation
Memory Stick. Left Control Set FOCUS Switch N - Slide switch forward and hold to put camcorder into manual focus and move focus point closer to camcorder. F - Slide switch backward and hold to put camcorder into manual focus and move focus point further from camcorder. - Page 5 B Button Video Out Bulkhead Port Pre-Dive Checklist Install a Mini DV / Digital 8 tape and Memory Stick in the camcorder. Install a completely charged battery in the camcorder. Verify operation of all housing controls. Check that the front bayonet port is securely engaged and that the latch pin is in the locked position.
-
Page 6: Returning Products For Care
O-ring Care & Maintenance O-rings are the critical component that keeps water out of the housing. Routinely inspect o-rings and replace at least once a year. If your o-rings are damaged, contact the Light & Motion service department for an o- ring replacement kit. - Page 7 300 Cannery Row • Monterey, CA 93940 (831) 645-1525 • Fax (831) 375-2517 www.uwimaging.com...