Setting Up Your Icebox; Installing The Batteries - Beyond Icebox Flipscreen Owner's Manual

FlipScreen Owner's Manual

Setting Up Your iCEBOX

Installing the
Batteries
!
6
Before you turn on your iCEBOX, you will need to install the batteries in the
remote and keyboard and set up the connections to support the many fea-
tures of the iCEBOX. These connections may include:
•
Your television cable or antenna
•
Any additional video sources (such as a camera and/or satellite cable)
•
The included FM Radio antenna
•
A PCMCIA Network card and an Ethernet cable or phone line.
• A SANI network card if you have other Beyond Appliances
The final thing you should do is plug in the power cord before turning on
the device. Figure 5 shows the rear panel connections on the iCEBOX.
The remote requires two AAA batteries (supplied), and the keyboard
requires two AA batteries (supplied). Alkaline batteries are recommended.
To install the batteries for your remote
On the back of the remote, remove the battery cover by loosening the
1.
small screw in the center of the panel ( fig. 3). Keep the attached
washer with the screw.
Install two AAA batteries, ensuring that the polarity (+ and –) on the
2.
batteries matches the + and – markings in the battery compartment.
Reattach the battery cover, making sure that the cover is seated
3.
properly.
Insert the screw, with the washer still attached, and tighten the screw
4.
until it is snug.
Do not overtighten the screw. You may damage the
Caution:
washer and the remote will no longer be washable.