Related Manuals for Aim LCU–ONE CAN
Summary of Contents for Aim LCU–ONE CAN
- Page 1 LCU–ONE CAN connected to MyChron 4 User manual...
-
Page 2: Table Of Contents
Chapter 3 – Connection with MyChron4 ..............6 Chapter 4 – Configuration on MyChron4 ..............7 Chapter 5 – Visualisation on MyChron4 ..............8 Chapter 6 – Data Analysis with Race Studio Analysis ..........9 Appendix – Technical drawings ................. 10 www.aim-sportline.com... -
Page 3: Chapter 1 - Lcu-One
• placing it in contact with inflammable stuff or fuel. Please note: disrespect of these precautions can cause shocks, burnings or explosions. 1.1 – Part Numbers LCU-ONE CAN part numbers are: • Controller LCU-ONE (Complete kit with Lambda probe) X08LCU03K0; • BOSCH LSU 4.9 Lambda probe X05LSU490. www.aim-sportline.com... -
Page 4: Chapter 2 - Lcu-One And Lambda Probe Mounting
N.B. BOSCH LSU 4.9 Lambda probe has been designed to be used with unleaded or diesel engine: it can be used with other kind of engines too but its duration needs to be verified by the user with specific tests. www.aim-sportline.com... - Page 5 We would suggest to install Lambda controller and the related probe as shown in the following figures. It is suggested to place LCU-ONE highlighted below under the kart number plate: Let the power cable (2) and the probe cable (1) pass around the steering wheel castle. www.aim-sportline.com...
- Page 6 Probe cable should be fixed to the driver seat as in the figure below: The probe should be inserted in the most suitable location of the exhaust pipe. We would suggest to install it in the exhaust pipe flexible tube (see figures below): Lambda Probe www.aim-sportline.com...
-
Page 7: Chapter 3 - Connection With Mychron4
Though the system is powered through Lambda controller connected to the battery, it is suggested to leave in MyChron 4 and in the possible eBox the related internal batteries. Lambda controller switches automatically off when MyChron4 is switched off. www.aim-sportline.com... -
Page 8: Chapter 4 - Configuration On Mychron4
Pressing “ENTER” the desired input is set. Available options are: • M4 T1: MyChron4 Temperature; • M4 T2: MyChron4 2 Temperature (only 2T version); • eBoxT1: eBox 1 Temperature (assuming this peripheral is connected); • eBoxT2: eBox 2 Temperature (assuming this peripheral is connected); www.aim-sportline.com... -
Page 9: Chapter 5 - Visualisation On Mychron4
• Sensor Open: the probe is not connected to the controller and the circuit is open • Sensor Fault: short circuit on the wiring During the session, lambda value page showa lambda value (1) and the selected temperature (2). www.aim-sportline.com... -
Page 10: Chapter 6 - Data Analysis With Race Studio Analysis
In this way a more immediate reading of carburation status will be available. At www.aim-sportline.com, “Download Area”, “On-track sessions” Pdf documents concerning track tests and related data analysis for a correct use of LCU-ONE CAN with MyChron4 are available. -
Page 11: Appendix - Technical Drawings
LCU-ONE CAN connected to MyChron4 User Manual Release 1.04 Appendix – Technical drawings www.aim-sportline.com... - Page 12 LCU-ONE CAN connected to MyChron4 User Manual Release 1.04 www.aim-sportline.com...
Need help?
Do you have a question about the LCU–ONE CAN and is the answer not in the manual?
Questions and answers