Advertisement
Transportation wheels for KLLST-2
For better transportation we worked two wheels into the rear feet of the big chair. You can just
tip over the chair and roll it away. But, please never do it with a person inside, because the
wheels are not made for that kind of weight.
Accessories
ARM, pair armrests for KLST-1 and KLST-2, 14 x 6.8 x 4.8''
The armrests support the arms and the palm of the hands can rest on the balls.
This allows the vibration from the chair to be transfered and to stimulate the hands.
These armrests are simply put on the sides of the chair (for both models KLST-1 and KLST-2)
and can be moved any way and position. It is recommended to tighten them completly after
you have the most comfortable place for the armrests. They are screwed tight with both screw
balls at their side. The vibration is transfered very good.
Recommended tuning c:
20 (30) overtone string
c
20 (30) braided bass string
C
The strings can be tuned a full tone higher or lower than the recommended base tone c (b,c,d)
The tuner
(a)
(b)
(c)
(d)
(on/off)
This compact and easy to use tuner encompasses the whole range of tones from C1 (32,70Hz) to C8 (4186,01Hz) .
Our recommendation for the tuning is to set the tuner to 432 or 440 Hz (a).
If the tuner is set an another frequency you can change the frequence by pressing the button (d).
This tuner works best when used in a low noise environment.
This tuner displays the notes like this: C,D,E,F,G,A,B, no matter which octave .
For example c' and c will be displayed as „C".
The included tuner is designed to be used in a silent environment. If you have to tune in a noisy
environment we recomment a clipon tuner (CA-AW3G) or a contact microphone (CA-CM200).
This allows you to tune independent of the noise level around you.
Both are not included and can be purchased through feeltone.
2
Advertisement
