Starting the CRxVision
To start the CRxVision:
Make sure:
The CRxVision is connected to the workstation either by point-to-point network or via
the local area network.
The workstation is running the appropriate acquisition software.
Do not insert an image plate if the CRxVision is switched off or starting up.
1. Press the power button.
POWER
The CRxVision starts the following sequence:
Initialization of all components.
Functional test of all components.
Check for presence of image plates.
Establish connection to the workstation.
During the self-test, which takes approx. 1 minute, the CRxVision status indicator is blinking
red.
Note: During the self-test, you cannot activate any function.
If the CRxVision has completed the self-test successfully, the CRxVision waits for the scan or
erasure command from the workstation: The status indicator is slow red blinking (
28
1 / sec.)
CRxVision Operating Manual V1.2
.