Class D amplifier, integrated in an easy to carry backpack. Every Partybag 6 features: a woofer (1), a tweeter (2), 2 bass reflex ports (3), a control and I/O panel (4), two side pockets (5), an upper pocket (6) and a carrying handle (7).
10. MIC/Line selector for Jack 6.3 mm input: sets the Jack 6.3 mm input in “MIC” mode to connect microphones or instruments without preamp, or “LINE” to connect line level audio sources.
NOTE: it is suggested to set the volume high enough on the audio source in use before intervening on the Partybag master volume, while still avoiding the limiter LED to turn on. If the limiter LED turns on the audio source volume may be too high.
Page 5
Use the “Play-Pause”, “Forward” and “Back” buttons to manage playback via Bluetooth® • NOTE: if no device is connected to Partybag's Bluetooth® for 60 seconds, it will turn off to save battery power. To switch the Bluetooth® on again press the corresponding button, the battery level indication LEDs will flash to indicate that the Bluetooth®...
Page 6
To connect several Partybag in daisy-chain it is necessary, after connecting the first of them to an audio source as described above, to use a Jack 6.3 mm mono cable to connect the LINE OUT of the first Partybag to the Jack 6.3 mm input of the second Partybag.
WARNING: to preserve the battery range, it is recommended to perform a full recharge at least once every 6 months, even if the Partybag is not used. Do not leave the battery fully discharged for long periods of time, it may be damaged permanently.
8” by FaitalPRO® (Power handling 130 W RMS) Amplifier: Class D 2x50 W RMS, DSP controlled Enclosure: Plywood, with bass-reflex INPUT/OUTPUT: Analog inputs: Jack 6.3 mm (unbalanced) with selectable MIC/LINE level, 2xRCA Digital inputs: MP3/USB Player, Bluetooth® receiver Analog outputs: Jack 6.3 mm (unbalanced) Jack MIC/LINE sensitivity:...