Related Manuals for Option Technologies OptionPower OptionFinder G2
Summary of Contents for Option Technologies OptionPower OptionFinder G2
- Page 1 ® OptionFinder Hardware Guide for OptionPower © 2005 Option Technologies Interactive, All Rights Reserved...
- Page 2 1. Connect the base station to your computer. 2. Click No, not at this time on the Windows “New Hardware Found” dialog and then click Next. 3. Click Install from a list or specific location, and then click Next. © 2005 Option Technologies Interactive, All Rights Reserved...
- Page 3 9. Press a number key on a keypad. 10. The number you pressed should appear to the right of the keypad address. 11. Test all keypads. 12. Click Close and then click Finish. © 2005 Option Technologies Interactive, All Rights Reserved...
- Page 4 1. Hold down the Clr key. 2. Press 9-5-1 and then release the Clr key. Two horizontal bars will appear in the LED. 3. Enter the three digits of the new address. © 2005 Option Technologies Interactive, All Rights Reserved...
-
Page 5: Troubleshooting
Cause The keypad address is outside of the defined keypad universe. Solution: Change the keypad address or change the keypad universe. Cause: The keypad is too far away from the base station. © 2005 Option Technologies Interactive, All Rights Reserved... - Page 6 7. Click Include this location in the search and then browse for the file c:\Program files\Common files\OptionTech Shared\Drivers\OptionFinder G2 USB Drivers. 8. Click Next. 9. Repeat the steps 7 – 9 if prompted to install the drivers again. © 2005 Option Technologies Interactive, All Rights Reserved...
Need help?
Do you have a question about the OptionPower OptionFinder G2 and is the answer not in the manual?
Questions and answers