Instructions for Operation and Care of GlacierFreeze
TROUBLESHOOTING
What should I do if my GlacierFreeze is too warm?
•
Adjust Cold Control. See page 3.
•
Make sure door is closed properly.
•
Condenser coils on back may need cleaning. See
page x.
--------------------------------------
What should I do if moisture collects on the outside?
•
Frequent door openings in high humid conditions
will cause this. Reduce door openings and reduce
time door is open.
•
Make sure door seal is tight.
WIRING DIAGRAM
POWER INLET
L
N
4
WHITEHALL MANUFACTURING • P.O. BOX 3527 • City of Industry, CA 91744-0527 U.S.A
Phone (800) 782-7706 • (626) 968-6681 • Fax (626) 855-4862 • Web: www.whitehallmfg.com
THERMOSTAT
YEL
GRN
GND
WHT
What should I do if my GlacierFreeze is too noisy?
•
Make sure cabinet is level, not touching a wall or
other surface, and rests squarely on the floor on all
four corners.
Make sure condenser coils are free of lint and dust.
•
Normal noises include refrigerant gurgling as it
•
passes through tubes and the compressor clinking
on and off.
What should I do if there is an odor coming from my
GlacierFreeze?
Clean interior. See page 3.
•
GRAY
RUNNING
CAPACITOR
PTC THERMISTER
--------------------------------------
COMPRESSOR
GND