Advertisement
PB-07
On this model the sensor is on the flat side.
You can attach the included plastic clip and the 4 mm screw on your PB-07.
You can use any 4 mm screw up to 5 mm inside of the PB-07 case. Do not
use longer screws as to prevent touching the connectors and damaging
them. Clip the PB-07 to the mic stand and the clip will disappear behind the
stand.
The
PB-07
can
be
connected
directly
to
a
gooseneck
microphone as well. The PB-07 is ideal for lead and back-up vocals,
acoustical instruments, talk-back mics, lecterns and podiums.
If you use a console with less than 48V phantom power or if your condenser
mic needs more than 10 mA then just send the Optogate to us and we will
modify it to work with your equipment, without any cost.
The Optogate devices were developed for use with professional equipment
and should be used by only professional system engineers and operators.
Please be aware that we are not responsible for any hazards or damages due
to the using of the Optogate devices. The Optogate devices are registered
under the number DE54933725 WEEE as B2B
devices. We also declare that they conform to the CE and ROHS for the
European market.
NOTE:
Removal of face plates and/or tampering with electronics voids warranty.
If you have further questions please don't hesitate to contact us:
Phone: 805.766.0069
Email: info@optogatesolutions.com
Advertisement
