Advertisement
Quick Links
What's in the box:
1.
Mirror with attached aerial
2.
Remote control with fitted battery
3.
4 x Fixing screws, raw plugs and 3
grommets
4.
Fixing Template
5.
Install and operation instructions
Please carefully inspect the mirror to en-
sure no damage has occured in transit. If
any damage is evident please photograph
both the mirror and any damage to the
packaging and contact us directly.
SAFETY
• THE MIRROR MUST BE INSTALLED BY A COMPETENT PERSON IN
ACCORDANCE WITH CURRENT IEEE REGULATIONS.
• IF IN DOUBT CONSULT A "PART P" REGISTERED ELECTRICIAN.
• THE MIRROR MUST BE PERMANENTLY INSTALLED AND NOT
CONNECTED TO A TRAILING PLUG/SOCKET.
• THE MIRROR MUST BE EARTHED.
• The product is for indoor use only in a ventilated bathroom. It is not
suitable for saunas, steam rooms or shower cubicles.
• The mirror is suitable for installation in Zone 2 and outside zones. It must
not be installed in Zone 0 or Zone 1. Please refer to the diagram.
Music in Every Room Ltd
Tenor Audio Mirror
Bluetooth
FM/DAB Radio
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Music in Every Room Tenor Audio Mirror
- Page 1 Music in Every Room Ltd Tenor Audio Mirror Bluetooth FM/DAB Radio What’s in the box: Mirror with attached aerial Remote control with fitted battery 4 x Fixing screws, raw plugs and 3 grommets Fixing Template Install and operation instructions Please carefully inspect the mirror to en- sure no damage has occured in transit.
- Page 2 1.Selecting the installed position Do not install in Zone 0 or Zone 1, or a position where it can be accidentally sprayed down with the shower head. It will require a mains cable feed to the rear of the case. (see wiring section) and ideally a co- axial feed for a remote aerial.
- Page 3 2. Reception The mirror has its own fitted aerial which in strong signal areas will be adequate. Mounting near a window generally improves reception. For best performance we strongly recommend a coaxial feed is run to a full external DAB/FM aerial, roof or loft mounted.
- Page 4 Disconnect: Low Voltage DC Plug - Black 2 x Speaker cables - Red Aerial “F” Connector - Brown LED Strip light connector - Red/Black Earth Tag - -Green/Yellow Once all cables have been disconnected lift the glass clear of the case to a safe position Take care to protect the edges of the glass, do not stand the mirror on its glass edge unless protected by soft material.
- Page 5 4 x Keyhole slots Cable entry for mains feed and coaxial Drill the wall for rawl plugs, 4 x 8mm rawl plugs and screws are provided but contractors must assess and pro- vide fixings appropriate for the wall-- Solid, Stud, Dot and Dab, etc.
- Page 6 6. Hanging the mirror Hang the case securely to the wall and wire in the mains cable. With the case wired and securely hung, offer up the glass and loosely fit the two top screws as indicated Swing the glass outwards always supporting the base and remake the connections. Connect: Low Voltage DC Plug - Black...
-
Page 7: Installation
FULLY RECESSING THE MIRROR It’s possible to fully recess the mirror. It will then operate: • Wired to on-wall or ceiling speakers • Wired to an external FM/DAB aerial • Rewire the LED to the room, or a separate light switch 1.Installation Cut a hole in the wall 774mm high 535mm wide. - Page 8 Split the glass fropm the case as previously described. Remove the side mounting aerial by removing the screws shown, push the aerial back through the hole to remove, refit the screws and fit the blanking grommet fitted in the rear of the case. 2.
-
Page 9: Auxiliary Audio Input
Speakers Disconnect the inbuilt speakers and rewire to the rear of the case for ceiling or wall speakers. Leave aprox 1m of cable exiting from one of the rear holes, gromet supplied. Wire to terminal blocks positioned between the batons. We can offer an excellent range of appropriate speakers.
Need help?
Do you have a question about the Tenor Audio Mirror and is the answer not in the manual?
Questions and answers