Subscribe to Our Youtube Channel
Summary of Contents for Cuprinol Power Pad for Decking
- Page 1 USER GUIDE Visit our website www.cuprinol.co.uk for a step by step product demonstration...
- Page 2 • Do not submerge the applicator into water • Cuprinol PowerPad Decking Stain has been higher than the hinge lock. specially formulated and the bottle has been designed to fit into the applicator perfectly •...
- Page 3 • Do not tamper with the batteries. will become permanently damaged. • The pad should be removed (using the • When replacing batteries, follow tabs) from the Cuprinol PowerPad before manufacturer instructions. cleaning. • When storing, remove the 4 x AA batteries •...
-
Page 4: Table Of Contents
ICI Paints AkzoNobel, Wexham Road, EN61000-3-2/-3 Slough, SL2 5DS, UK Tel: 0870 444 1111 www.cuprinol.co.uk PRODUCT SPECIFICATION Model No: CUP077040 ICI Cuprinol, Commons Road, Cork, Ireland Unit dimensions: Tel: 021 422 0222 Height: 140cm Fax: 021 422 0205 Width: 20cm www.cuprinol.i.e... -
Page 5: Getting To Know The Powerpad
GETTING TO KNOW THE POWERPAD Trigger Handle Stem 1 Stem 2 Stem 3 Stem 4 Bottle holder Cleaning cap Battery cover release catch Spike/air bleed valve Bottle Battery Bottle release holder cover holder Main casing Hinge lock Brush strip Dispensing spout... -
Page 6: Assembly
ASSEMBLE THE STEM Stem 4 Stem 3 Stem 2 Stem 1 IMPORTANT: Take care when handling the wired stem sections. Do not pull or strain the wires or damage could be caused. Insert stem 3 into stem 4 (connected to the PowerPad), it will ‘click’ into position when fitted correctly. -
Page 7: Setting Up The Powerpad
THE STAIN BOTTLE SETTING UP THE POWERPAD Prongs Fit the stain bottle Shake the bottle for at least 10 seconds before removing With the lid removed, push fit the stain bottle into the bottle the lid. Do not attempt to holder, it will ‘click’... -
Page 8: Using The Powerpad
USING THE POWERPAD PowerPad Decking Stain will be touch dry in 2-6 hours in good drying conditions. When applying subsequent coats, allow to dry fully before recoating. Avoid heavy wear and tear for a few days after application. Apply 2-3 coats depending on the colour and degree of protection required. -
Page 9: Replacing Batteries
REPLACING BATTERIES Lugs 1. Press down on the catch to unclip the battery cover. 2. Completely remove the battery cover from the main casing. 3. Remove the used batteries. Insert 4 x AA replacement batteries into the battery casing as shown above. - Page 10 CLEANING AND MAINTENANCE - continued Cleaning the pad Cleaning the brush strip Press the trigger to flush water through the system, Wear gloves when cleaning Place the pad holder into remove as much water the pad. Use your fingers to clean, cold water and soak as possible and repeat if work the fluid out of the pad...
-
Page 11: Trouble Shooting
Pour out any remaining water. Visit either www.cuprinol.co.uk or www.cuprinol.i.e for more technical advice. GUARANTEE The guarantee is valid for one year from date of • Damage caused by misuse or improper handling of... - Page 12 Cuprinol, the tree device, PowerPad and the distinctive livery are trademarks of AkzoNobel © AkzoNobel 2009. CUP077040. DATE: MARCH 2009...
Need help?
Do you have a question about the Power Pad for Decking and is the answer not in the manual?
Questions and answers