should begin emitting smoke or odors. Please unplug the KineticTV box’s power adapter when not in use for a prolonged period. Accessory List Please open the package and check to ensure the following accessories are included: TV Box x1...
KineticTV RSTV-A4K-16 Quick Reference Guide V1.1 Hardware Standby Key Power LED Net LED IR LED Side Panel TF Card USB1 USB2 TF CARD Rear Panel DC in HDMI output S/P DIF Optical output IR in Micro USB Etherne AV output HDMI S/P DIF...
KineticTV RSTV-A4K-16 Quick Reference Guide V1.1 Remote Control Standby On/Off Mute Up/Down Enter/Confirm Direction Key L/R Direction Key HOME Page Back/Exit Bluetooth Voice Volume + Volume - Instructions Indicator Light: Press any key and indicator light flashes 【Note】 The indicator light will flash quickly when the remote batteries are low, please replace the batteries with approved Alkaline models.
Page 5
Joystick/Game Controller to operate in the specific application. These are not included with your service. KineticTV Important Account Details (Please fill out the below information for your convenience.) Windstream Account Number: KineticTV Box Serial Number: KineticTV Box MAC ID: KineticTV Support Number: 800-347-1991...
IR IN Internet Connection Step1: Connection to TV Connect the supplied HDMI / AV cable to the HDMI / AV output port of the KineticTV box and to an HDMI/AV input on your TV. Step2a: Connection to your network wired Connect the Ethernet cable to the LAN port of the KineticTV box, and an open Ethernet port on your router or broadband network.
Page 7
Note: Before powering on, please switch the signal input of the TV to the correct source. Connect the power adapter to the KineticTV box, connect the AC Adapter to a powered wall outlet. After connecting the KineticTV box will start automatically.
KineticTV RSTV-A4K-16 Quick Reference Guide V1.1 Technical Specifications ARM Quad 64-bit Cortex-A53 up to 1.5GHz Android OS Android TV 9.0 Video/Audio output S/P DIF H.265 10-bit 4K*2K@60fps, H.264 AVC/MVC Video format 4K*2K@30fps, VP9, AVS+, MPEG1/2/4 ASP, WMV/VC-1, RealVideo8/9/10 and other video formats MPEG1/2/4, MP3, AAC/AAC+, WMA/WMA-pro, FLAC, Audio format OGG and other audio formats...
Possible reason Solution The device is in Press the Standby Power mode Standby power mode button on the KineticTV box Make sure the TV is on and the No display after TV is not on the correct Input Source is selected...
Page 10
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.