Advertisement
Table of Contents
THE WIRELESS TEMP SENSOR SYSTEM IS MADE UP OF AT LEAST ONE THERMOSTAT WITH A
S1-LXRFM THERMOSTAT RF MODULE INSTALLED AND AT LEAST ONE WIRELESS TEMP SENSOR.
One outdoor sensor and up to 8 indoor sensors may be used with 1
thermostat.
The thermostat automatically averages the temperatures from up to 8
linked wireless indoor sensors.
If more than 1 wireless indoor sensor is used with 1 thermostat, then
each sensor must have a different ID Number.
SUGGESTED USES FOR ONE WIRELESS TEMP SENSOR:
To report the outdoor temperature when using a compatible thermostat.
It is recommended to attach the wireless sensor to a north-facing wall
where it will not be in direct sunlight or the spray of sprinklers.
To report the temperature of a room, such as that of a baby's room when
using a compatible thermostat.
To control the temperature in a space that is different from where a
compatible thermostat is located.
To average with a thermostat's internal sensor.
SUGGESTED USES FOR MULTIPLE WIRELESS REMOTE SENSORS:
To control to the average of multiple wireless sensors in a large open
space using a compatible thermostat. This type of application would
include large, open office areas.
To average with a thermostat's internal sensor.
IMPORTANT: DO NOT MOUNT SENSOR IN DIRECT SUNLIGHT
Using the supplied screws, attach the rear housing
the mounting surface. For outdoor applications it is
recommended to install the sensor on a surface that is
not in direct sunlight. The components of the sensor
have been precoated at the factory to give limited
protection against moisture.
Installation
Install 2) AAA batteries as illustrated above.
Battery type recommendation:
Temperature range: 32-120 Fahrenheit, Alkaline.
Temperature range: 0-130 Fahrenheit, Lithium.
Patent Pending
WIRELESS TEMP SENSOR
Setup & Installation
to
DIP Switch
Batteries
The S1-LXRFTS requires 2 AAA batteries.
The wireless sensor must be linked to a thermostat with an
RF Module installed for proper communication and operation.
S1-LXRFTS
WIRELESS TEMP SENSOR
Front Cover Removed
Top
Link LED
Mounting
Screw
Legend
S1-LXRFM
RF Module
Accessory
(ACCSRY)
Button
P/N 88-812
Link Button
DIP
Switches
Bottom
Mounting
Screw
Rev. 3
Advertisement
Table of Contents
Summary of Contents for Source 1 LX Series
- Page 1 S1-LXRFTS WIRELESS TEMP SENSOR THE WIRELESS TEMP SENSOR SYSTEM IS MADE UP OF AT LEAST ONE THERMOSTAT WITH A S1-LXRFM THERMOSTAT RF MODULE INSTALLED AND AT LEAST ONE WIRELESS TEMP SENSOR. One outdoor sensor and up to 8 indoor sensors may be used with 1 thermostat.
- Page 2 S1-LXRFTS WIRELESS TEMP SENSOR Startup To startup the Wireless Temp Sensor, install the batteries as shown on the reverse page. Upon startup, the LED will flash once indicating the the sensor has been started or reset. After a pause, any additional flashes will indicate how many thermostats the sensor is currently linked to.
Need help?
Do you have a question about the LX Series and is the answer not in the manual?
Questions and answers