IMPORTANT - ALL PARTS & COMPONENTS MUST NOT BE REMOVED OR REPLACED UNLESS BY QUALIFIED SERVICE PERSONNEL. - CHECK THE DATA PLATE TO ENSURE THE APPLIANCE IS SUITABLE FOR THE AVAILABLE GAS SUPPLY. - TO ENSURE THE SAFETY AND CORRECT USAGE OF THIS APPLIANCE, READ THE INSTRUCTIONS CAREFULLY AND FOLLOW THE INSTALLATION GUIDE.
INSTALLATION INSTRUCTIONS These instructions are written for qualified technicians. They serve as a guide for installation, adjustment and maintenance in accordance with existing laws and standards. All the procedures must be duly completed before the appliance is connected with electricity. 1.
INSTRUCTIONS FOR USERS This hob is only used with gas only as it is indicated below the hob. IGNITION OF BURNER 1. Check to make sure that the gas supply is accessible and set up with the necessary and appropriate fittings/connectors. 2.
CAUTIONS 1. The hose must never reach, in any point, a temperature of c. Use the adequate sealing washer ONLY. The gas flexible hose must never in contact with bottom panel. 2. The gas flexible hose must be fixed to the cook top connection by metal clip.
Page 6
BATTERY COMPARTMENT 1. New battery should be replaced the old one if it runs flat. 2. The battery compartment is located as shown in the diagram. Please place the battery in correct position as shown. Do not spray aerosols on this hob while the flame is on as the propellant gases could break down when heated and produce abrasive vapors that could corrode the hob.
MAINTENANCE CLEANING THE TOP PLATE 1. Persistent stains may require heavy rubbing with nylon brush or detergent. Harsh abrasive cleaners, powder cleaners, steel wool or wax polishes are not allowed to use as it spoil the hob. 2. Do not use alkaline detergent, petrol, corrosive or bleaching material to clean the hob. 3.
HOB WITH SAFETY DEVICE 1. Safety device is equipped with automatic shut off gadget. When the flame is extinguished by the wind or overflow of food, this device will automatically cut off the gas supply for your safety. 2. Turning the knob clockwise to “off” position, a click sound will be heard, the gas supply is shut off and the flame will extinguish.
Need help?
Do you have a question about the AHN2 Calibre Duo and is the answer not in the manual?
Questions and answers