Assembly And Mounting - Farmi Forest Corporation CR46 Operation, Maintenance And Spare Parts Manual

ASSEMBLY AND MOUNTING

Read these instruction before
starting any assembly or moun-
!
ting work. Improper mounting
work can cause hazards during
use of the crane. Mounting car-
CAUTION!
ried out in a manner other than
that specified in this manual can expose the user to
danger and will void the manufacturer's guarantee.
Check the stability of the crane-vehicle assembly by
performing the necessary calculations. See "Determi-
ning the stability".
The mounting must be performed by the manufac-
turer or a service center or person authorized by the
manufacturer.
The strength class of the mounting bolts is 10.9. Use
self-locking nuts, e.g., DIN985.
Put all screws into place. First tighten all screws in threa-
ded holes to torque, and then all screws in unthreaded
holes.
Retighten the bolts after the test
run and the first day of use.
!
CAUTION!
When mounting the crane on a foundation not delive-
red by FARMI Forest, use the mounting plate shown in
figure 1.In mounting, allow enough space for servicing
and repairs.
Fig 1.
CR46
INSTALLATION INSPECTION
Decisions 354/83 and 530/83 made by the Finnish
Council of State stipulate that an installation inspection
must be performed for each crane-vehicle assembly
before use.
An inspection form can be found in this manual.
The person performing the inspection must be familiar
with the crane's construction and operation.
MOUNTING THE MULTI- AND DOUBLE-ACTING
VALVES
!
CAUTION!
Install the valve using the included bracket at the
desired location, paying attention to the direction of
the hoses and movement during loading and trans-
ferring so that there is no risk of abrasion or clamping.
The label indicating the safe distance from live
conductors must be clearly visible during operation.
!
DANGER!
The levers in the multi-lever valve can be moved to
different positions if necessary. Detach the levers from
the valve before moving them.
14
The valve must be positioned or
covered so that the levers cannot
be used inadvertently.
Hoses in the operator's cabin
must be protected so that the
user is not endangered by oil jets
in the event of breakage.