Advertisement
INTERPHONE INSTRUCTIONS
There are only four buttons that you need to consider (Volume + and -,
Reset/Off and the Interphone button).
To turn on and connect two (V6) units:
Start with both V6 units turned off. (Press the RESET button to turn off)
On both units simultaneously, press and hold the INTERPHONE button until the
LED flashes red and blue continuously. Release the INTERPHONE buttons
when you see both units flashing red and blue.
On the first unit, press the INTERPHONE button. The LED will flash blue as it
seeks to pair with the other. Wait for 5-10 seconds, after which time the LED
on the other unit should also start to flash blue.
Press the INTERPHONE button again on the first unit to set the communication
channel between the two units.
Adjust the volume (+/-) as necessary
When finished, turn off the units by pressing the RESET/OFF button
If you press one of the other buttons during a match, you may lose the
communication channel between the two units, although the connection should
still remain. You should be able to recover communication by either pressing
the INTERPHONE button again, or by pressing the green telephone button (if
that was the one that was pressed)
Volume +
Reset / Off
Interphone
button
Volume -
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for VnetPhone Riders V6
Summary of Contents for VnetPhone Riders V6
- Page 1 INTERPHONE INSTRUCTIONS There are only four buttons that you need to consider (Volume + and -, Reset/Off and the Interphone button). To turn on and connect two (V6) units: Start with both V6 units turned off. (Press the RESET button to turn off) On both units simultaneously, press and hold the INTERPHONE button until the LED flashes red and blue continuously.
- Page 2 Headsets The Jabra Wave headset is connected to the Interphone via the 3.5mm audio socket. It must be connected using the small adapter cable supplied (only one adapter cable though !). The eargel can be rotated through 180 degrees to allow you to wear the headset in either right or left ear.
- Page 3 To connect THREE units, using the coach (V4) interphone. Vol - radio Interphone/ON Vol + Reset the pairings Start with the V4 (Coach) unit Press and hold the INTERPHONE/ON button until the LED flashes blue Reset any existing pairing by pressing and holding both A and B buttons until the LED flashes red before switching to flashing blue.
- Page 4 Connect the third unit Turn the V4 unit back on by pressing and holding the INTERPHONE/ON button until the LED flashes blue Press and hold button B on the V4 unit whilst at the same time press and hold the INTERPHONE button on the second V6 unit until the LED on both units are flashing red and blue continuously.
Need help?
Do you have a question about the Riders V6 and is the answer not in the manual?
Questions and answers
I have installed both units into the helmets. I have paired them however I can speak to my partner and he can hear me - but I can’t hear him? Any advice please?
If you can speak to your partner using the VnetPhone Riders V6 but cannot hear him, try the following:
1. Check if the headset is properly connected to the Interphone using the correct adapter cable.
2. Make sure the earpiece is correctly positioned and securely attached.
3. Verify the volume setting using the Volume + and Volume - buttons.
4. If the connection was lost during a match or movement, press the INTERPHONE button again to recover communication.
5. If the green telephone button was used, press it again to restore audio.
These steps should help restore two-way communication.
This answer is automatically generated
What is the jack wiring for the 6 rider